We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat beige ribbon cable with multiple connectors on each end

DELL

DELL Latitude 5175 5179 Ribbon Cable 75FT3 accessory

SKU CH-J24Z-SV7GK

Genuine Dell OEM ribbon cable connects the palmrest junction board to the motherboard for Latitude 5175 and 5179 2-in-1 tablets

  • Genuine Dell OEM part ensures exact fit for Latitude 5175 and 5179
  • Connects palmrest junction board to motherboard restoring full keyboard and touchpad function
  • Direct replacement for Dell part number 75FT3 matches original specifications
  • Designed for Latitude 11 2-in-1 models 5175 and 5179 guaranteeing compatibility
  • New condition ribbon cable ready for immediate installation without wear concerns

Genuine Dell OEM Ribbon Cable 75FT3

This genuine Dell OEM ribbon cable carries part number 75FT3 and connects the palmrest junction board to the motherboard. It is built for the Latitude 11 5175 2-in-1 and the Latitude 11 5179 2-in-1. The part replaces AAJA0 and NBX0001UY00 in those systems.

Installation and Handling

The cable is a flat flexible circuit that routes through the hinge area of the 2-in-1 chassis. Careful alignment during reassembly prevents pinching or creasing that would interrupt the signal path. No additional tools or adhesives are required beyond those used for the palmrest removal.

Compatibility Decides Fit

This ribbon cable fits only the Latitude 11 5175 and Latitude 11 5179 models listed above. It will not work in other Latitude tablets, other 2-in-1 sizes, or any non-Dell device. Buyers who need a cable for a different model must source the correct part number for that system.

Highlights

  • Genuine Dell OEM part ensures exact fit for Latitude 5175 and 5179
  • Connects palmrest junction board to motherboard restoring full keyboard and touchpad function
  • Direct replacement for Dell part number 75FT3 matches original specifications
  • Designed for Latitude 11 2-in-1 models 5175 and 5179 guaranteeing compatibility
  • New condition ribbon cable ready for immediate installation without wear concerns

Specifications

BrandDell

Questions about this item

How do I install the 75FT3 ribbon cable between the palmrest junction board and the motherboard on a Latitude 5175 2-in-1?

Remove the tablet section from the keyboard base, disconnect the old cable from both the palmrest junction board and the motherboard, then connect the new 75FT3 cable to the same two connectors ensuring the latch clicks shut.

Will the 75FT3 ribbon cable need periodic replacement on my Latitude 5179 2-in-1?

The cable is a passive flex circuit with no moving parts; it only requires replacement if the conductors fracture from repeated flexing or if the connector ends are damaged during service.

What is the first failure sign of the 75FT3 cable under daily detach/attach cycles on a Latitude 11 5175?

Intermittent loss of keyboard, trackpad or fingerprint-reader function appears first when the flex conductors begin to crack near the folding zone.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.