DELL
DELL Inspiron 15 7558 7568 Touchpad Ribbon Cable 9XD6W accessory
Genuine Dell OEM touchpad ribbon cable for Inspiron 15 7558 and 7568 laptops
- Genuine Dell OEM part ensures exact fit for Inspiron 15 7558 and 7568
- Connects touchpad assembly to motherboard restoring full cursor control
- Part number 9XD6W matches Dell service documentation for accurate replacement
- Alternate references Blackwood-MLK-TP-FFC and 450.05P04 cross-check to same component
- New condition guarantees unused factory-quality ribbon cable ready for installation
Genuine Dell OEM touchpad ribbon cable
This genuine Dell OEM ribbon cable connects the touchpad assembly on Inspiron 15 7558 and 7568 notebooks. It carries Dell part number 9XD6W and matches the Blackwood-MLK-TP-FFC and 450.05P04 alternates. The part is supplied new and ready for installation.
Passive flex circuit with no active cooling
The cable is a passive flexible flat circuit that draws no power and generates no heat during normal operation. It has no fan, no active components and therefore produces zero noise. Thermal behaviour is limited to the ambient temperature inside the laptop chassis.
Designed for continuous signal integrity
Under sustained use the flex maintains consistent conductivity between the touchpad and motherboard. It does not throttle, overheat or degrade signal quality over time. The part is not a security lock and will not fit models outside the listed Inspiron 15 7558 and 7568 series.
Highlights
- Genuine Dell OEM part ensures exact fit for Inspiron 15 7558 and 7568
- Connects touchpad assembly to motherboard restoring full cursor control
- Part number 9XD6W matches Dell service documentation for accurate replacement
- Alternate references Blackwood-MLK-TP-FFC and 450.05P04 cross-check to same component
- New condition guarantees unused factory-quality ribbon cable ready for installation
Specifications
| Brand | Dell |
|---|
Questions about this item
How do I route the 9XD6W ribbon cable through the hinge area when installing it in an Inspiron 7558?
Disconnect the battery, remove the bottom cover, release the ZIF connector latch on the touchpad board, thread the flat cable through the hinge channel without twisting it, then reseat the latch and reassemble.
Will the 9XD6W cable need periodic replacement or just inspection?
The ribbon cable is a passive flex circuit with no moving parts; it only requires replacement if the conductors fracture from repeated hinge flexing or the connector pads corrode.
What failure appears first on the 9XD6W cable during heavy daily 2-in-1 mode switching?
Repeated folding at the hinge crease stresses the copper traces, so intermittent touchpad loss or ghost clicks typically emerge before the connector itself fails.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Kensington Desk Mount Cable Anchor K64613WW accessory
- Black
- Provides a secure a…
Panasonic CF-VDR291U laptop cooling pad
- Optical Drive
- Buffer Size: 2 MB B…
eReplacements PB992A-ER laptop battery 14.4V
- Battery
- Lithium-Ion



