We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat ribbon cable with connectors for Alienware 13 logo LED board

DELL

DELL Alienware 13 Logo LED Cable A148S2

SKU CH-WQHR-X63DQ

Connects the Alienware 13 logo LED board to illuminate the front bezel

  • Connects the Alienware 13 logo LED board
  • Lights the front bezel Alienware logo
  • Genuine Dell OEM replacement cable A148S2
  • Fits Alienware 13 display assembly
  • Direct swap for part ZAP00 LOGO CABLE

Replacement LED logo cable for Alienware 13

This genuine Dell cable connects the logo LED board inside the display assembly to illuminate the Alienware branding on the front bezel. It is designed specifically for the Alienware 13 laptop model. The part restores the distinctive lighting effect when the original cable fails or is damaged during service.

Part number A148S2 ensures correct fit

The cable carries Dell part number A148S2 and alternate references ZAP00 LOGO CABLE and DC020020W00. Using this exact part number guarantees compatibility with the Alienware 13 display assembly. No other part numbers are supported for this specific logo illumination function.

Not for other Alienware models or non-LED bezels

This cable only fits the Alienware 13 and will not work with other Alienware laptop sizes or models. It also cannot be used on systems where the front bezel lacks the illuminated logo feature. Buyers needing a different display cable or a complete hinge assembly should look for the appropriate separate part.

Highlights

  • Connects the Alienware 13 logo LED board
  • Lights the front bezel Alienware logo
  • Genuine Dell OEM replacement cable A148S2
  • Fits Alienware 13 display assembly
  • Direct swap for part ZAP00 LOGO CABLE

Specifications

BrandDell

Questions about this item

Will the A148S2 logo cable need replacement if the Alienware 13 lid hinge damages the ribbon?

The cable connects the logo LED board inside the display assembly; if hinge wear pinches or tears the ribbon, the logo will stop lighting and the cable must be replaced.

What is the first sign that the A148S2 cable is failing under daily open-close cycles?

Intermittent or dead "ALIENWARE" logo illumination on the front bezel appears first, caused by conductor fatigue inside the display hinge area.

Does the A148S2 cable draw enough power to add noticeable heat or fan noise when the logo stays lit all day?

The cable only carries low-voltage LED current for the front-bezel logo, adding negligible heat and no audible fan impact during continuous use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.