We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 3.5 inch SAS hard drive with green circuit board visible

DELL

DELL 91K8T 3TB 7.2K 3.5" SAS internal hard drive

SKU CH-672D-A38X6

A 3.5-inch SAS desktop drive with 3 TB capacity and 7.2 K RPM spindle speed

  • 3 TB capacity stores large data sets
  • 2 K RPM spindle delivers steady throughput
  • SAS interface connects to compatible controllers
  • 5 inch form factor fits standard drive bays
  • EAN 4054317896203 identifies the exact part

Dell 3 TB Nearline SAS Drive

This new Dell 91K8T hard drive delivers 3 TB of storage in a 3.5 inch form factor. It spins at 7.2 K RPM and connects through a 6 Gbps SAS interface. The unit ships tested with updated firmware in ESD-safe packaging.

Suited for SAS servers and arrays

The drive fits servers and storage arrays that accept 3.5 inch SAS drives running at 6 Gbps. It is not for systems that lack a SAS controller or that require a 2.5 inch form factor. Buyers needing a different capacity or interface should consider other models.

6 Gbps SAS interface is the deciding spec

The single specification that determines compatibility is the 6 Gbps SAS interface. Verify that your backplane or controller supports this exact protocol before ordering. The 91K8T part number and EAN 4054317896203 confirm the exact unit.

Highlights

  • 3 TB capacity stores large data sets
  • 2 K RPM spindle delivers steady throughput
  • SAS interface connects to compatible controllers
  • 5 inch form factor fits standard drive bays
  • EAN 4054317896203 identifies the exact part

Specifications

No published specifications for this item yet.

Questions about this item

Will the 3.5" Dell 91K8T fit a standard 3.5-inch drive bay and SAS backplane?

Yes, the 3.5-inch form factor matches standard desktop drive bays and the SAS interface connects directly to a compatible SAS backplane or controller.

What is the correct way to install the 91K8T so the SAS connector seats properly?

Align the drive with the bay guides, slide it in until the SAS data and power connector fully engages, then secure it with the mounting screws supplied by the chassis.

How often should I check the 7.2K RPM drive health and when might replacement be needed?

Monitor SMART attributes monthly; replace the drive if reallocated sector counts rise or if the firmware reports imminent failure during routine checks.

New to this? Paying with USDT: TRC-20 or ERC-20 — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.