We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Case of 24 rolls of red double-coated polypropylene tape 2 inches wide 60 yards long

Decker Tape Products, Inc.

Decker Tape Products, Inc. Double Coated Red Polypropylene Tape 2" x 60 Yd Case of 24 Rolls

SKU CH-4Y9C-AEB62

Double-coated red polypropylene tape with rubber adhesive holds splices securely, offering 28 lbs/in tensile strength and 130 oz/in adhesion across a 0–120 °F range

  • Strong holding power from 130 oz/in rubber adhesive
  • Handles heavy loads with 28 lbs/in tensile strength
  • Performs in extreme cold to 120°F operating range
  • Thin 5 mil profile fits tight splices cleanly
  • 24 rolls per case supply high-volume splicing needs

Double-coated red polypropylene tape

This double-coated red polypropylene tape comes in a case of 24 rolls, each 2 inches wide and 60 yards long. It uses a rubber adhesive system that provides 130 oz/in of adhesion and 28 lbs/in tensile strength. The 5 mil thickness and 55 percent elongation suit splicing and marking tasks where high tack is required. It operates across a temperature range of 0 to 120 degrees Fahrenheit.

Upgrade from single-coated or lower-tack tapes

Switching from single-coated alternatives adds adhesive on both sides for immediate bonding between two surfaces. The jump is worth it when splicing webs or rolls where removal must be clean and the red colour must remain visible for identification. Lower-tack products may release under tension or temperature swings that this tape withstands.

Sustained load behaviour

Under continuous tension the 28 lbs/in tensile strength holds splices without snapping, while the rubber adhesive resists creep across the full 0 to 120 degree Fahrenheit range. The 5 mil carrier maintains dimensional stability during prolonged stress rather than stretching beyond its 55 percent elongation limit. Adhesion stays consistent through thermal cycling instead of decaying after an initial burst.

Highlights

  • Strong holding power from 130 oz/in rubber adhesive
  • Handles heavy loads with 28 lbs/in tensile strength
  • Performs in extreme cold to 120°F operating range
  • Thin 5 mil profile fits tight splices cleanly
  • 24 rolls per case supply high-volume splicing needs

Specifications

BrandThe Tape Supplies Shop

Questions about this item

What width and length does each roll of the 2" x 60 Yd double coated red polypropylene tape measure?

Each roll is 2 inches wide and 60 yards long, and the case contains 24 rolls for bulk use.

How do I apply the rubber adhesive tape correctly, and what step do people often miss?

Clean the surface thoroughly, then press the tape firmly across the full 5 mil thickness to activate the 130 oz/in adhesion; skipping surface prep is the common mistake.

When will the tape need replacement based on its temperature limits and tensile rating?

Replace the tape if it sees temperatures above 120 °F or below 0 °F, or once the 28 lbs/in tensile strength degrades after repeated stress cycles.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.