We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black laptop CPU cooling fan with three-pin connector

DBTLAP

DBTLAP Laptop CPU Fan for Packard Bell ms2273 3 pin Cooling Fan

SKU CH-60ZT-VHREF

Replacement CPU cooler with three-pin connector for Packard Bell ms2273 laptops, tested before dispatch

  • Accessory TypeCooler
  • Direct replacement for Packard Bell ms2273 models
  • 3-pin connector matches original motherboard header
  • Pre-tested unit verified to spin at 100%
  • Forcecon, ADDA, Sunon or Kipo manufacture
  • Single fan ships ready for immediate installation

Replacement CPU Fan for Packard Bell ms2273

This replacement CPU fan fits the Packard Bell ms2273 laptop and uses a three-pin connector for power and speed reporting. It is intended for owners who need to replace a worn or noisy original cooler. Buyers should verify the exact dimensions and mounting holes against the original part before ordering. The fan is supplied as a single unit without additional brackets or thermal compound.

Tested Operation and Three-Pin Control

Each unit is tested before dispatch to confirm it spins correctly and reaches the expected RPM range. The three-pin interface allows the motherboard to monitor fan speed and adjust voltage for quieter operation under light loads. Power draw stays within the limits of the original laptop cooling circuit. No separate power adapter or software utility is required for basic thermal management.

Forcecon ADDA Sunon Kipo Build Variants

The fans are sourced from Forcecon, ADDA, Sunon, Kipo or equivalent manufacturers depending on stock, so the exact bearing type and blade profile may vary between units. All variants share the same three-pin connector and mounting layout for the ms2273 chassis. The package includes only the fan itself; screws, cables or thermal pads are not supplied. A nine-month warranty covers defects in materials and workmanship.

Highlights

  • Direct replacement for Packard Bell ms2273 models
  • 3-pin connector matches original motherboard header
  • Pre-tested unit verified to spin at 100%
  • Forcecon, ADDA, Sunon or Kipo manufacture
  • Single fan ships ready for immediate installation

Specifications

Accessory TypeCooler

Questions about this item

How do I install this fan in my Packard Bell ms2273 and which step is often missed?

Align the screw holes with the heatsink, connect the 3-pin cable to the motherboard header, then secure the screws evenly; the step most people miss is plugging the 3-pin connector in fully before tightening the screws.

What maintenance or replacement will this fan need later?

Dust builds up on the blades and heatsink fins over time; clean it with compressed air every few months and replace the fan if bearing noise appears or airflow drops noticeably.

What limit appears first when this fan runs continuously under load?

The 3-pin design provides constant voltage, so speed cannot be reduced by the system; sustained high RPM leads to increased bearing wear and audible noise before thermal limits are reached.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.