DBTLAP
DBTLAP Forcecon F82V DFS531205LC0T 5V 0.5A 3-pin fan for Dell Studio 1450 1457 1458 p03G laptop cooling pad
Replacement 3-pin 5V 0.5A cooling fan for Dell Studio 1450, 1457 and 1458 laptops
- Accessory TypeCooler
- Compatible with Dell Studio 1450 1457 1458 p03G models
- 5V .5A power rating matches original Forcecon F82V spec
- 3-pin 3-wire connector fits existing motherboard header
- Tested before shipping for reliable operation out of the box
- Direct replacement part number DFS531205LC0T ensures exact fit
Replacement Fan for Dell Studio Laptops
This 5 V 0.5 A three-pin fan fits Dell Studio 1450 1457 and 1458 models using the Forcecon F82V DFS531205LC0T part number. It is a direct swap for a worn or noisy original cooler in those machines.
Upgrading From a Failed Original Cooler
The part replaces the factory fan when bearings wear out or airflow drops below what the chassis can dissipate. The jump is worth it when the laptop throttles or shuts down under load because the old cooler can no longer move enough air.
Limits of a Single 3-Pin 5 V Fan
A three-pin 5 V fan runs at a fixed voltage so speed control depends on the laptop's own PWM header or voltage regulation. It cannot exceed the current draw the motherboard header supplies and it offers no onboard temperature sensing or speed reporting.
Highlights
- Compatible with Dell Studio 1450 1457 1458 p03G models
- 5V .5A power rating matches original Forcecon F82V spec
- 3-pin 3-wire connector fits existing motherboard header
- Tested before shipping for reliable operation out of the box
- Direct replacement part number DFS531205LC0T ensures exact fit
Specifications
| Accessory Type | Cooler |
|---|
Questions about this item
Does the 3-pin connector on this Forcecon F82V fan match the motherboard header on a Dell Studio 1450?
The fan uses a 3-pin 5 V 0.5 A connector designed for Dell Studio 1450, 1457 and 1458 models; verify the header layout in the product photos before fitting.
What is the common mistake when installing this DFS531205LC0T fan in a Dell Studio laptop?
Installers often skip comparing the replacement to the original fan shown in the photos, leading to mismatched pin-outs or mounting tabs.
When should the 5 V 0.5 A fan in this cooling pad be replaced again?
Replace the fan if airflow drops, bearing noise appears or the 3-pin connector becomes loose after extended use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



