We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black laptop CPU cooling fan with wire connector

DBTLAP

DBTLAP CPU Cooling Fan for HP EliteBook Folio 1040 G3

SKU CH-MRS8-R66SY

Replacement CPU cooling fan for HP EliteBook Folio 1040 G3, rated 5V 2.5W and tested before shipping

  • Accessory TypeCooler
  • Designed for HP EliteBook Folio 1040 G3 exact fit
  • 5 V 2.5 W power rating matches original spec
  • Replaces part EG50040S1-C530-S9A for direct compatibility
  • Every unit tested before shipping to ensure reliability
  • Single fan cooler accessory type for targeted CPU cooling

Replacement Fan for EliteBook Folio 1040 G3

This replacement cooling fan is built for the HP EliteBook Folio 1040 G3 laptop. It matches part number EG50040S1-C530-S9A and restores factory airflow when the original cooler fails or becomes noisy. Each unit is tested before it leaves the supplier.

Thermals, Noise and Power Draw in Normal Use

The cooler runs at 5 V and draws 2.5 W, keeping power consumption low during everyday workloads. It spins only as fast as the system demands, so acoustic output stays modest while the CPU remains within its normal temperature range.

Behaviour Under Sustained Load

During extended sessions the fan maintains continuous airflow without throttling back, preventing thermal buildup that can slow the processor. The 100 % pre-shipment test confirms reliable operation over long periods rather than just in short bursts.

Highlights

  • Designed for HP EliteBook Folio 1040 G3 exact fit
  • 5 V 2.5 W power rating matches original spec
  • Replaces part EG50040S1-C530-S9A for direct compatibility
  • Every unit tested before shipping to ensure reliability
  • Single fan cooler accessory type for targeted CPU cooling

Specifications

Accessory TypeCooler

Questions about this item

How do I install the DBTLAP cooling fan in my HP EliteBook Folio 1040 G3 and which step causes the most problems?

Remove the bottom case, disconnect the old fan cable from the motherboard header, then fit the replacement EG50040S1-C530-S9A unit. The step most people miss is reseating the connector fully so the 5 V 2.5 W motor gets stable power.

What maintenance will this fan need later and when should I plan a replacement?

Blow dust from the heatsink fins every six months with compressed air. If bearing noise appears or RPM drops under load, replace the fan — the 5 V 2.5 W motor is rated for continuous use but not user-serviceable.

What thermal limit shows up first during sustained heavy workloads on this EliteBook Folio 1040 G3 cooler?

The 5 V 2.5 W fan reaches its maximum airflow before the CPU hits throttle point, so the limit is the fan’s own RPM ceiling under prolonged load.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.