DBTLAP
DBTLAP Cooling Fan for EG75070S1-C480-S9A DC5V 2.25W 4PIN
Replacement cooling fan for compatible laptops, rated DC5V 2.25W with a four-pin connector
- Accessory TypeCooler
- Direct replacement for EG75070S1-C480-S9A laptops
- DC5V 2.25W power draw keeps energy use low
- Four-pin connector enables precise speed control
- Each unit tested before shipping for reliability
- Real-item photos let you verify exact match
Replacement fan for EG75070S1-C480-S9A
This DBTLAP cooling fan is a direct replacement for the EG75070S1-C480-S9A model used in compatible laptops. It operates at DC5V with a 2.25W power rating and connects via a 4PIN interface. The part is intended for owners who need to swap out a failed or noisy original cooler.
Upgrading from a worn original cooler
The fan replaces the factory-fitted unit when bearings wear out or airflow drops below specification. A jump is worth it when the original fan spins loudly, overheats the chassis, or stops spinning entirely. Buyers who want more airflow than the stock design provides should look elsewhere, as this part matches the original 480 specification.
Straightforward 4PIN swap with visual checks
Installation involves disconnecting the old 4PIN connector and fitting the new fan in the same mount, a process that typically requires only a screwdriver and patience. Each unit is tested before shipping. The most common issue is ordering a mismatched part number; verify the photos and model number against your existing fan before purchasing.
Highlights
- Direct replacement for EG75070S1-C480-S9A laptops
- DC5V 2.25W power draw keeps energy use low
- Four-pin connector enables precise speed control
- Each unit tested before shipping for reliability
- Real-item photos let you verify exact match
Specifications
| Accessory Type | Cooler |
|---|
Questions about this item
Will this fan fit the EG75070S1-C480-S9A part number exactly?
Yes, the fan is built for the EG75070S1-C480-S9A model and matches the photos shown; compare your original part to the images before ordering.
How do I install the 4-pin DC5V 2.25W fan without damaging the connector?
Align the four-pin plug with the motherboard header, press straight in until seated, and avoid forcing it at an angle which can bend pins.
When should I plan to replace this cooling fan again?
Replace it if bearing noise appears, airflow drops noticeably, or the fan fails to spin at the rated 5 V supply; each unit is tested before shipping.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



