We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black 7015 cooling fan with wire leads

DBTLAP

DBTLAP ADDA AD07012HX159300 12V .35A 7015 cooling fan

SKU CH-M4TW-040D7

A 12V 0.35A replacement cooling fan for Optoma projectors, tested before shipping

  • Accessory TypeCooler
  • Compatible replacement for Optoma projectors
  • 12V .35A power rating matches original spec
  • 7015 form factor fits existing mounting points
  • Each unit tested before shipping for reliability
  • Verify part number AD07012HX159300 for exact fit

Replacement fan for Optoma projectors

This 12 V, 0.35 A cooling fan carries the ADDA AD07012HX159300 part number and is built to fit compatible Optoma projector models. It arrives as a single tested unit ready for direct installation. Buyers who need a different voltage, connector layout or physical footprint will not be served by this part.

Upgrade from a worn or noisy original

The fan replaces an aging ADDA 7015 series cooler that has become loud, vibrates or no longer spins at full speed. Swapping it restores the airflow the projector’s thermal design expects and avoids shutdowns caused by overheating. The jump is worth it when the original bearing noise is audible or the projector reports a fan error.

Fits into the projector’s existing cooling assembly

The unit mounts in the same housing and connects to the same header as the factory fan, requiring no wiring changes or firmware updates. It frees up the thermal headroom needed for stable lamp or laser operation during long sessions. Installers should verify the part number against the service manual before opening the chassis.

Highlights

  • Compatible replacement for Optoma projectors
  • 12V .35A power rating matches original spec
  • 7015 form factor fits existing mounting points
  • Each unit tested before shipping for reliability
  • Verify part number AD07012HX159300 for exact fit

Specifications

Accessory TypeCooler

Questions about this item

What are the exact dimensions and mounting-hole pattern of the 7015 fan so I can confirm it fits my Optoma projector?

The fan is a 7015 frame size; compare the photos and your original part number to verify the mounting holes match before ordering.

How do I install this 12V .35A replacement fan and what step do people often miss?

Disconnect power, swap the old fan, and reconnect the same two-wire plug; the step most people miss is confirming the part number matches exactly for 100% compatibility.

When will this ADDA AD07012HX159300 fan need replacement and how can I tell?

Each unit is tested before shipping; replace it when airflow drops or noise rises, and always verify the 159300 part number on the label before ordering a new one.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.