DBTLAP
DBTLAP 19V 2.37A Power Adapter for Acer Aspire S7 S7-392 9890 3.0mm*1.1mm
Supplies 19V 2.37A power to Acer Aspire S7 S7-392 9890 via a 3.0 mm × 1.1 mm tip
- TypeAC Adapter
- Delivers 19 V 2.37 A for stable laptop charging
- 0 mm × 1.1 mm barrel tip fits Acer Aspire S7 S7-392 9890
- Includes adapter and power cord for immediate use
- Each unit tested before shipping for reliable operation
- New condition ensures full performance from first plug-in
DBTLAP 19V 2.37A AC Adapter
This DBTLAP adapter supplies 19V at 2.37A for compatible Acer Aspire ultrabooks. It includes the adapter unit and a mains power cord in the box. The barrel connector measures 3.0mm outer by 1.1mm inner diameter. Buyers should verify the tip against their original unit before ordering.
Replaces worn or lost Acer 19V chargers
The unit matches the original 19V 2.37A specification for the listed Aspire models. It serves as a direct replacement when the factory charger fails, is lost or shows cable damage. Each item is tested before shipping to confirm correct output. The jump is worth it when the original adapter no longer delivers stable power.
Handles 19V 2.37A ultrabook loads
The adapter comfortably powers the supported Aspire S7 series notebooks under normal workloads. It runs out if the device demands more than 2.37A at 19V or if the connector polarity and dimensions do not match exactly. Users with different voltage or tip requirements cannot use this model.
Highlights
- Delivers 19 V 2.37 A for stable laptop charging
- 0 mm × 1.1 mm barrel tip fits Acer Aspire S7 S7-392 9890
- Includes adapter and power cord for immediate use
- Each unit tested before shipping for reliable operation
- New condition ensures full performance from first plug-in
Specifications
| Type | AC Adapter |
|---|
Questions about this item
Will the 3.0 mm by 1.1 mm barrel tip fit my Acer Aspire S7-392 charging port?
Yes, the adapter uses a 3.0 mm outer diameter and 1.1 mm inner diameter barrel connector that matches the Aspire S7-392 and 9890 models.
Do I just plug the IEC C7 mains lead into the brick and the barrel into the laptop, or is there a polarity switch to set?
Connect the supplied figure-8 mains cord to the adapter, then insert the 3.0 mm barrel into the laptop; the tip is centre-positive so no switch is needed.
How long before the 19 V 2.37 A brick or its detachable mains cord typically needs replacing?
The adapter and its IEC C7 cord are rated for several years of daily use; replace either piece if the barrel becomes loose, the cord frays, or output voltage drops below 19 V.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



