Dayton
Dayton 5ZK66 Recessed Electric Wall-Mount Heater Stainless Steel
A stainless-steel recessed or surface-mount electric wall heater delivering 750 or 1000 watts at 208/240 V AC with a 3.6/4.2 amp draw and 81 °F temperature rise
- ColorStainless Steel
- Dual mounting fits shallow recessed or surface walls
- Stainless steel grille resists corrosion in damp areas
- 750 or 1000 watt output matches room size
- 208/240 volt single-phase supply suits standard wiring
- 81 °F temperature rise delivers rapid comfort
Shallow Recessed Wall Heater
The Dayton 5ZK66 is a stainless steel electric heater designed for shallow recessed or surface mounting on walls. It operates on 208/240 V AC single phase power at 60 Hz and delivers selectable output of 750 or 1000 Watts. The steel grille measures 10 1/2 inches wide by 14 1/2 inches high with a 1 1/4 inch depth.
Light Commercial and Residential Spaces
This unit suits light commercial and residential rooms where a low-profile wall heat source is required. The wall opening depth of 2-1/2 inches fits standard shallow cavities. Buyers needing higher heat output or a different voltage supply should look at other models.
Dual Wattage 750/1000 Watts
The selectable 750 or 1000 Watt rating determines the heating capacity and electrical load at 3.6 or 4.2 Amps. This single figure decides whether the heater matches the circuit capacity and the room size requirements.
Highlights
- Dual mounting fits shallow recessed or surface walls
- Stainless steel grille resists corrosion in damp areas
- 750 or 1000 watt output matches room size
- 208/240 volt single-phase supply suits standard wiring
- 81 °F temperature rise delivers rapid comfort
Specifications
| Brand | DAYTON |
|---|---|
| Color | Stainless Steel |
Questions about this item
What voltage does the 5ZK66 heater use, and what current does it draw at each setting?
The unit runs on 208/240 V AC single-phase and draws 3.6 amps at 750 watts or 4.2 amps at 1000 watts.
What wall opening is required for recessed mounting of this stainless-steel heater?
Cut an opening 9-3/16 in. wide, 12-5/8 in. high and 2-1/2 in. deep for the housing to sit flush.
How is the heater secured during installation, and which step is often missed?
Fasten the housing to wall studs through the built-in mounting tabs; the step often missed is verifying the 2-1/2 in. recess depth before closing the wall.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
