We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black rubber banded V-belt, two joined bands, wrapped edges, 98.8 in outside length

Dayton

Dayton 3HEZ6 2/B95 banded v-belt 98.8 in outside length

SKU CH-K015-081X7

A two-band wrapped rubber V-belt, 98.8 in outside length, for heavy industry and HVAC drives

  • Dual-band design distributes load evenly across two belts
  • Wrapped rubber construction resists abrasion in heavy-industry use
  • Polyester reinforcing cords maintain tension under high torque
  • Operates reliably up to 194 °F in HVAC and industrial drives
  • Fits pulleys as small as 5.4 in pitch diameter for compact layouts

What this belt is and who needs it

The Dayton 3HEZ6 is a banded V-belt built for heavy industry, HVAC and light industry drives. It replaces a single 2/B95 belt where two bands share the load across matched pulleys. Maintenance teams and OEMs use it on closed-loop drives that demand the Power King Combo series construction. It is not for drives that require a single-band B-section belt or a different industry number.

The specification that confirms fit

The outside length is 98.8 in and the top width measures 1 21/64 in across two bands. Industry number 2/B95, belt trade size B and a minimum pulley pitch diameter of 5.4 in are the decisive dimensions. If your drive calls for a different length, band count or pulley diameter, this belt will not install correctly.

Heat, noise and power in normal use

The rubber compound with polyester reinforcing cord is rated to a maximum operating temperature of 194 degrees F. Wrapped edge construction and rubber coating keep running noise low on matched sheaves. Power capacity follows standard B-section banded ratings for the given pulley diameter and wrap angle; no separate wattage figure applies to the belt itself.

Highlights

  • Dual-band design distributes load evenly across two belts
  • Wrapped rubber construction resists abrasion in heavy-industry use
  • Polyester reinforcing cords maintain tension under high torque
  • Operates reliably up to 194 °F in HVAC and industrial drives
  • Fits pulleys as small as 5.4 in pitch diameter for compact layouts

Specifications

No published specifications for this item yet.

Questions about this item

What does the 98.8 in outside length mean when the belt is installed on pulleys?

The 98.8 in outside length is the total circumference measured around the outer surface of the belt when it is laid flat, which determines the centre-to-centre distance required between the driver and driven pulleys for correct tension.

What does the industry number 2/B95 tell me about the belt cross-section and how it fits the pulley groove?

The 2/B95 designation indicates a banded belt with two B-section ribs, each having a standard top width of approximately 1 21/64 in and a thickness of 1/2 in, designed to run in matched B-series pulley grooves with a minimum pitch diameter of 5.4 in.

What are the physical dimensions I need to check for clearance and mounting on my drive?

The banded belt has an overall top width of 1 21/64 in across both ribs, a thickness of 1/2 in, and an outside length of 98.8 in, so verify that the pulley face width, guard clearance, and shaft centre distance can accommodate these measurements.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.