We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Dayton 12 V DC utility pump in plastic housing

Dayton

Dayton 3ACA5 12 V DC 1/12 HP Utility Pump Trap

SKU CH-4NXW-X6VVY MPN 3ACA5

A 12 V DC utility pump delivers up to 3.4 gpm at 10 ft head with a maximum lift of 7.5 ft and 40 ft total head

  • TypeDrain Components
  • Self-priming operation simplifies setup
  • 12 V DC power suits mobile or off-grid use
  • 4 gpm flow at 10 ft head delivers practical output
  • 40 ft maximum head handles elevated discharge
  • 3 psi max pressure supports hose connections

Pump for 12 V DC utility drainage

The Dayton 3ACA5 is a self-priming utility pump with a plastic housing and Buna-N impeller. It runs on 12 V DC at 7.5 amps and delivers a maximum flow of 3.4 gpm at 10 ft of head. Suction lift reaches 7.5 ft and total head capacity is 40 ft. Discharge and intake connections are 3/4 in hose and MGHT types respectively.

Suits portable low-pressure transfer.

This pump fits mobile or off-grid jobs where a 12 V supply is available and head stays below 40 ft. It handles fluids up to 3,000 SUS viscosity and self-primes for quick start-up. Buyers needing more than 17.3 psi operating pressure or AC-powered operation should look elsewhere. The 1 ft cord also limits placement without an extension.

Handles up to 40 ft head and 3.4 gpm flow

At 10 ft of head the pump moves 3.4 gpm, and it can push water to a maximum of 40 ft total head. Self-priming works within the 7.5 ft suction lift limit. Performance drops as head approaches the 40 ft maximum and pressure nears 17.3 psi. Viscous fluids near the 3,000 SUS ceiling will further reduce flow and head capability.

Highlights

  • Self-priming operation simplifies setup
  • 12 V DC power suits mobile or off-grid use
  • 4 gpm flow at 10 ft head delivers practical output
  • 40 ft maximum head handles elevated discharge
  • 3 psi max pressure supports hose connections

Specifications

TypeDrain Components
BrandDayton
Model3ACA5

Questions about this item

What power supply must I already have to run this 12 V DC pump?

You need a 12 V DC source capable of delivering at least 7.5 amps.

Will the 3/4 inch hose and MGHT intake connections fit the fittings I already use?

Yes — the discharge is a 3/4 in hose barb and the intake is a 3/4 in MGHT thread, both common garden-hose sizes.

How can I verify the pump is performing correctly after installation?

At 10 ft of head you should see up to 3.4 gpm flow; the pump self-primes with a maximum suction lift of 7.5 ft and can develop 40 ft total head at 17.3 psi.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.