Dayton
Dayton 33NT15 DC Power Supply 90-264V AC 12V DC 15W 1.25A DIN Rail
Converts 90 to 264V AC to 12V DC at 15W with DIN-rail mounting and IP20 protection
- Wide 90 to 264V AC input handles global mains
- 12V DC at 1.25A delivers 15W reliable power
- DIN rail mounting fits standard control panels
- Green DC OK indicator confirms output status
- IP20 rated plastic case protects internal components
Power supply for DIN rail panels
This 12 V DC unit delivers 15 W from a 90 to 264 V AC source and mounts on standard DIN rail. It suits control cabinets, automation rigs and industrial enclosures that need a compact, single-phase converter.
Replaces bulkier linear units
The switching design cuts heat and width to 0.9 in while keeping output noise at or below 1 percent. The jump makes sense when panel space is tight and a green DC OK indicator simplifies commissioning.
Handles sensors, relays and small PLCs
At 1.25 A continuous the supply runs typical 12 V field devices with 16 ms hold-up through brief mains dips. It reaches its limit with larger contactors or multiple high-draw modules, so size the load before specifying.
Highlights
- Wide 90 to 264V AC input handles global mains
- 12V DC at 1.25A delivers 15W reliable power
- DIN rail mounting fits standard control panels
- Green DC OK indicator confirms output status
- IP20 rated plastic case protects internal components
Specifications
| Brand | DAYTON |
|---|
Questions about this item
Does the 0.9 in width fit my DIN rail?
The plastic case is 0.9 in wide and 4.02 in deep, designed for DIN rail mounting.
Which wires go to the 90-264V AC input terminals?
Connect live and neutral to the AC input side; the unit accepts 47 to 63 Hz single-phase power.
When should I replace the unit if the green DC OK signal stays off?
If the green DC OK indicator remains unlit with valid 90-264V AC input, the supply has likely failed and should be replaced.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
