Dayton
Dayton 32V122 Open Drum Mixer 1/2 hp 35 in shaft 316 SS
Air-powered open drum mixer with a 35 in 316 stainless steel shaft and 1/2 hp motor for side clamp mounting
- TypeAngle, Pitch & Slope Locators
- Air-powered operation eliminates electrical hazards in wet areas
- 1/2 hp motor delivers 2,000 RPM for thorough blending
- 35-inch 316 stainless steel shaft resists corrosion in harsh chemicals
- Side clamp mounting fits open drums without permanent installation
- Fixed propeller handles all viscosity levels with consistent flow
Dayton 32V122 Open Drum Mixer
The Dayton 32V122 is an air-powered open drum mixer rated at 1/2 hp with a 35 in shaft made of 316 stainless steel. It mounts by clamp on the side of a drum and uses a fixed propeller to blend fluids at speeds up to 2,000 RPM. This tool is built for maintenance crews and process operators who need portable mixing in open containers.
Clamp mount and air supply needs
The mixer clamps to the drum side so no permanent tank modification is required, and the 35 in shaft reaches deep into standard drums. It runs on compressed air through a 1/4 in female NPT inlet, freeing the workspace from electric cords and allowing use where electrical equipment is restricted. A suitable air line and regulator must be provided on site.
Suits open-drum batch mixing.
This unit suits operators mixing compatible viscosities in open drums where a clamp mount and air power are practical. It does not fit sealed or pressurised vessels, nor applications that require a different shaft length, a different shaft material, or an electric drive. Buyers needing those configurations should look at other equipment.
Highlights
- Air-powered operation eliminates electrical hazards in wet areas
- 1/2 hp motor delivers 2,000 RPM for thorough blending
- 35-inch 316 stainless steel shaft resists corrosion in harsh chemicals
- Side clamp mounting fits open drums without permanent installation
- Fixed propeller handles all viscosity levels with consistent flow
Specifications
| Brand | Dayton |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
What limits continuous mixing time with the 1/2 hp air motor?
The air-powered motor runs as long as compressed air is supplied; duty cycle depends on your compressor capacity and air-line size.
How much noise and heat does the mixer produce during all-day operation?
The unit has no electric motor, so heat comes only from compressed-air expansion; sound level is that of the air exhaust and propeller action at up to 2,000 RPM.
What fittings must already be on the air supply for the 1/4 in female NPT inlet?
A 1/4 in male NPT connector on the hose is required to attach directly to the mixer's air inlet.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
