Dayton
Dayton 30G262 Selector Switch 22 mm 3 Position
22 mm selector switch with three positions, momentary-maintained-momentary action, two normally-open contacts rated 10 A at 600 V AC, and IP65 protection
- 22 mm mounting fits standard panels
- Three-position selector with momentary and maintained actions
- 10 A at 600 V AC contact rating for industrial loads
- IP65 and NEMA 4X ratings resist dust and water jets
- Extended black lever operator for clear manual control
22 mm Selector Switch for Control Panels
The Dayton 30G262 is a non-illuminated selector switch designed for 22 mm panel cut-outs. It provides three positions with a momentary-maintained-momentary action sequence. The extended lever operator is black plastic with a silver bezel. It suits industrial control panels and machinery interfaces requiring manual circuit selection.
NEMA 1 2 3 4 4X and IP65 Environmental Rating
The switch housing achieves NEMA ratings 1, 2, 3, 4, and 4X plus IP65 ingress protection. This seals the operator against dust, splashing water and hose-directed water. Contact blocks carry a 10A rating at 600V AC and 2.5A at 600V DC. The A600/Q600 designation confirms suitability for heavy-duty pilot duty.
Two Normally Open Contacts in Plastic Housing
The unit supplies a 2NO contact form without an included cam. All basic components including the operator head and bezel are plastic. It mounts in a standard 22 mm opening and occupies minimal depth behind the panel. Buyers needing illuminated operators, keyed removal or additional contact blocks must source those separately.
Highlights
- 22 mm mounting fits standard panels
- Three-position selector with momentary and maintained actions
- 10 A at 600 V AC contact rating for industrial loads
- IP65 and NEMA 4X ratings resist dust and water jets
- Extended black lever operator for clear manual control
Specifications
| Brand | DAYTON |
|---|
Questions about this item
How do I mount the 22 mm selector switch and what is the common wiring mistake?
Drill a 22 mm panel cut-out, insert the operator through the front and secure the locking nut from behind; the frequent error is swapping the two normally-open contact terminals so the circuit stays open in the maintained position.
Which parts will need replacement after extended operation?
The plastic operator head and internal contact blocks are the wear items; the 10 A AC / 2.5 A DC contacts can erode after many cycles, and the IP65 seal may degrade, requiring a new switch assembly.
What is the first performance limit reached during continuous duty?
The 10 A at 600 V AC contact rating is the limiting factor; sustained current above this level causes contact heating and premature failure before the IP65 or NEMA 4X enclosure ratings are challenged.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
