Dayton
Dayton 2VKL2 Wire Rope Thimble 5/16 In Steel Pack of 25
Steel wire-rope thimbles protect 5/16 in rope loops, zinc-plated for corrosion resistance, pack of 25
- TypeAngle, Pitch & Slope Locators
- Protects rope loops with 5/16 in compatibility
- Zinc-plated steel resists corrosion for longer service
- 25-piece pack supplies multiple rigging jobs
- Open-end design allows quick installation on site
- Meets lifting-capability rating for load-bearing use
Wire Rope Thimble 5/16 In
This Dayton wire rope thimble protects the eye of a 5/16 inch rope from wear and deformation under load. The zinc-plated steel construction resists corrosion in outdoor and marine environments. Each pack contains 25 pieces for rigging multiple assemblies. It is rated for lifting applications where a secure loop is required.
Replaces Worn Or Damaged Thimbles
Install these when an existing thimble shows cracking, elongation or heavy corrosion that compromises the rope eye. The upgrade is worth it whenever a sling or winch line is re-terminated after inspection reveals metal fatigue. Do not reuse a thimble that has been shock-loaded or shows visible distortion.
Open End Slides On Before Crimping
The open-end design lets the thimble slide onto the rope before a ferrule or clamp is swaged in place. Ensure the rope diameter matches the 5/16 inch specification so the thimble seats fully without gaps. A common error is forcing a larger rope into the groove, which prevents proper seating and reduces lifting capacity.
Highlights
- Protects rope loops with 5/16 in compatibility
- Zinc-plated steel resists corrosion for longer service
- 25-piece pack supplies multiple rigging jobs
- Open-end design allows quick installation on site
- Meets lifting-capability rating for load-bearing use
Specifications
| Brand | Dayton |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
What rope diameter does the 5/16 in thimble suit?
The thimble is made for 5/16 in wire rope, with an inside wall width of 7/16 in and loop inside width of 13/16 in.
How do I fit the thimble and what step is often missed?
Form the rope into a loop, slide the thimble inside, then secure with correctly sized clips; the step often missed is re-torquing the clips after the first load.
When should I replace these zinc-plated steel thimbles?
Replace any thimble showing corrosion through the zinc plating, deformation of the 1/8 in wall height, or elongation of the 1 1/2 in loop inside length.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
