We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Stainless steel utility pump with float switch and power cord

Dayton

Dayton 1XHV5 1 HP 2" Utility Pump 120V AC Float

SKU CH-2MTD-MTC85 MPN 1XHV5

One-horsepower utility pump with stainless-steel body and impeller delivers up to 90 gpm at 5 ft head and 49 ft maximum head on 120 V AC power

  • TypeDrain Components
  • 1 HP motor moves up to 90 gpm at 5 ft head
  • Stainless steel body and impeller resist corrosion
  • Carbon ceramic Viton shaft seal extends service life
  • 120 V AC plug-in operation requires no hard wiring
  • Maximum 49 ft head handles deep drainage tasks

1 HP Utility Pump for Drainage

This Dayton 1XHV5 is a 1 horsepower plug-in utility pump designed for water removal tasks. It operates on 120V AC single-phase power at 60 Hz and draws 11.3 amps. The stainless steel body and impeller with a carbon, ceramic, and Viton shaft seal provide durability for continuous drainage applications.

Float Switch Integration and Head Performance

The pump is supplied without a switch, requiring a separate float switch for automatic operation. It delivers 90 gpm at 5 ft of head, 82 gpm at 10 ft, 69 gpm at 15 ft, and 61 gpm at 20 ft, with a maximum shut-off head of 49 ft. The 2-inch discharge outlet connects to standard plumbing fittings for straightforward installation.

Upgrading from Lower-Capacity Drain Pumps

This model replaces smaller utility pumps when higher flow rates at elevated head pressures are needed. The jump is worth it for systems that must move larger volumes of water against greater vertical lift than fractional-horsepower units can sustain. It is not suited for applications requiring an integrated automatic switch or for handling solids-laden sewage.

Highlights

  • 1 HP motor moves up to 90 gpm at 5 ft head
  • Stainless steel body and impeller resist corrosion
  • Carbon ceramic Viton shaft seal extends service life
  • 120 V AC plug-in operation requires no hard wiring
  • Maximum 49 ft head handles deep drainage tasks

Specifications

TypeDrain Components
BrandDayton
Model1XHV5

Questions about this item

How long can the 1 HP motor run continuously before thermal protection trips?

The motor draws 11.3 amps at 120V AC, 60 Hz; sustained operation at high head will cause winding temperature to reach the internal thermal limit first.

What noise and heat levels should I expect when the pump runs all day at 90 gpm?

At 90 gpm and 5 ft head the unit moves 90 gallons per minute; motor and fluid noise increase with flow, and the stainless housing dissipates heat into the pumped liquid.

What discharge hose or pipe must I already have to connect the 2 inch outlet?

The pump has a 2 inch discharge; you need a 2 inch hose or pipe with a matching coupling and a 120V AC plug-in supply on a 15 amp circuit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.