We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black closed-loop timing belt with 225 teeth, 1800 mm length, 50 mm wide

Dayton

Dayton 1LVZ9 HT timing belt 225 teeth 1800 mm

SKU CH-6F20-5P29A

Neoprene HT timing belt with 225 teeth, 8 mm pitch and 1800 mm length for industrial power transmission

  • TypeBearings, V-belts & Power Transmission Equipment
  • ColorBlack
  • HTD timing belt for precise synchronous drives
  • 225 teeth on 8 mm pitch for exact positioning
  • 50 mm top width handles heavy industrial loads
  • Fiberglass-reinforced neoprene resists stretch and heat
  • Nylon tooth coating reduces wear from -22 °F to 194 °F

Dayton 1LVZ9 HT Timing Belt — What It Is

The Dayton 1LVZ9 is a closed-loop HT timing belt built from neoprene with a nylon tooth coating and a fiberglass reinforcing cord. It has 225 teeth, an 8 mm pitch and a pitch length of 1800 mm. The belt is supplied new and is intended for general industrial power-transmission use.

Who This Belt Suits — And Who It Does Not

Maintenance teams and OEM engineers who need a 50 mm wide HTD-profile belt rated from -22 to 194 degrees F will find the specification matches. Buyers who require a different tooth count, pitch, width or temperature range should look at other belt series because this model is fixed at the figures listed.

Installation Notes

The belt installs as a continuous loop over matching HTD pulleys; correct tension and alignment are essential to prevent premature tooth wear or cord fatigue. The most common issue is misaligned flanges or incorrect centre distance, which causes edge loading and shortens service life.

Highlights

  • HTD timing belt for precise synchronous drives
  • 225 teeth on 8 mm pitch for exact positioning
  • 50 mm top width handles heavy industrial loads
  • Fiberglass-reinforced neoprene resists stretch and heat
  • Nylon tooth coating reduces wear from -22 °F to 194 °F

Specifications

BrandDAYTON
TypeBearings, V-belts & Power Transmission Equipment
ColorBlack

Questions about this item

Does this 50 mm wide HTD belt fit the existing pulleys on my 8 mm pitch drive?

Yes, the belt uses an 8 mm pitch and HTD tooth profile, so it matches pulleys made for that pitch and width.

Can I run this belt on the same shafts as my current fiberglass-cord neoprene belt?

The cord material is fiberglass and the body is neoprene with a nylon tooth coating, so it behaves the same way on existing shafts.

How do I confirm the 225-tooth count is correct once the belt is installed?

Count the teeth on the installed loop; it must total 225, and the closed-loop length must measure 1,800 mm pitch length.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.