We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black closed-loop timing belt, 130 teeth, 1040 mm length, 85 mm wide

Dayton

Dayton 1LVT9 HT Gearbelt 130 Teeth 1040 mm collectible

SKU CH-Q8P4-M61Q3

Industrial timing belt with 130 teeth, 1040 mm pitch length and 85 mm width operates from -22 to 194 °F

  • TypeBearings, V-belts & Power Transmission Equipment
  • ColorBlack
  • HTD timing belt rated for -22 °F to 194 °F operation
  • 130-tooth profile ensures precise synchronous drive
  • 1040 mm pitch length fits standard 8 mm pitch systems
  • Fiberglass-reinforced neoprene resists stretch under load
  • Nylon tooth coating reduces wear and noise

Industrial Timing Belt For Power Transmission

The Dayton 1LVT9 is a closed-loop HTD timing belt built for general industrial power transmission. It uses a neoprene body with nylon tooth coating and fiberglass reinforcing cords. The belt runs on a single-sided tooth profile with a pitch of 8 mm and a pitch length of 1040 mm.

Suited For Synchronous Drives Not For Variable Speed

This belt suits machinery that requires precise synchronous motion at a fixed 8 mm pitch. It is not for buyers who need a V-belt profile, a different tooth count than 130 teeth, or a length other than 1040 mm. Applications demanding a wider top width than 85 mm or a double-sided tooth design should look at alternative constructions.

Straightforward Loop Installation Check Alignment

Installation consists of routing the closed loop over matching HTD pulleys and tensioning to the equipment specification. The fiberglass cords resist stretch but can be damaged by prying or sharp edges during fitting. Most issues come from misaligned pulleys or running outside the -22 to 194 Degrees F temperature range, which degrades the neoprene compound.

Highlights

  • HTD timing belt rated for -22 °F to 194 °F operation
  • 130-tooth profile ensures precise synchronous drive
  • 1040 mm pitch length fits standard 8 mm pitch systems
  • Fiberglass-reinforced neoprene resists stretch under load
  • Nylon tooth coating reduces wear and noise

Specifications

BrandDAYTON
TypeBearings, V-belts & Power Transmission Equipment
ColorBlack

Questions about this item

What pulleys must I already have for this 1040 mm HT belt with 130 teeth and 8 mm pitch?

Matching HTD pulleys with an 8 mm pitch, 130-tooth engagement and a width that accepts the 85 mm belt are required for proper meshing.

Can this fiberglass-cord neoprene belt run on older drives that used a similar 1040 mm length?

Only if the existing drive uses HTD 8 mm pitch pulleys; the fiberglass reinforcement and nylon tooth coating demand the exact tooth profile.

How do I confirm the belt is seated correctly after installation?

Verify the 130 teeth fully engage the pulley grooves, the 85 mm width sits flush, and tension allows smooth rotation without tooth skip.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.