Dayton
Dayton 1/8 in 100 ft 7x19 304 SS Cable 352 lb
1/8-inch diameter 7x19 stainless steel cable on a 100-foot reel with a 352 lb working load limit and vinyl coating
- 304 stainless steel resists corrosion
- 7x19 strand construction stays flexible
- 352 lb working load limit for lifting
- 100 ft vinyl coated length ready to use
- 1,760 lbf breaking strength adds safety margin
1/8 in 304 SS 7x19 Cable
This 100 ft length of 304 stainless steel wire rope uses a 7x19 strand construction with an IWRC core and a vinyl coating. It is rated for a working load limit of 352 lb and a breaking strength of 1,760 lbf. The plain ends allow direct attachment to compatible hardware for lifting or pulling tasks. The silver cable arrives unlubricated and new.
Rigging jobs needing flexible coated rope
The 7x19 construction suits applications where the line must bend around sheaves or drums without kinking. The vinyl coating provides a smoother surface for handling and protects the 304 stainless strands from abrasion. Buyers who need an uncoated rope for direct lubrication or a different alloy for harsher chemical exposure should look at other specifications.
352 lb working load limit decides fit
Every lift or pull must stay at or below the 352 lb working load limit to maintain the designed safety factor. The 1,760 lbf breaking strength represents the absolute failure point, not a working figure. Verify that your rigging plan and hardware ratings align with this limit before purchase.
Highlights
- 304 stainless steel resists corrosion
- 7x19 strand construction stays flexible
- 352 lb working load limit for lifting
- 100 ft vinyl coated length ready to use
- 1,760 lbf breaking strength adds safety margin
Specifications
| Brand | Dayton |
|---|
Questions about this item
Does the vinyl coating on the 1/8 in cable add noticeable friction or heat when running through pulleys all day?
The vinyl coating protects the 304 stainless steel core from corrosion and abrasion; the 7x19 construction remains flexible under continuous cycling.
What fittings or terminations are required to attach the plain ends of this 100 ft cable to my existing rigging?
The cable has plain ends, so you will need compatible 1/8 in wire-rope clips, thimbles or swaged sleeves rated for at least the 352 lb working load limit.
Will the 3/16 in overall diameter of this coated cable fit the sheave grooves on my older 1/8 in rated blocks?
The 3/16 in vinyl-coated diameter is larger than bare 1/8 in rope; verify your sheave groove width before use to avoid binding or premature wear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
