Dayton
Dayton 1/4 in Stainless Steel Cable 100 ft WLL 1152 lb
¼-inch 304 stainless-steel wire rope, 19×7 IWRC core, 100 ft length, 1,152 lb working load limit and 5,760 lbf breaking strength for lifting tasks
- 1/4 in diameter suits compact rigging
- 304 stainless steel resists corrosion
- 19 x 7 strand construction balances flexibility and strength
- 1152 lb working load limit for lifting tasks
- 100 ft length covers extended runs
Stainless Steel Cable for Lifting
This 1/4 in diameter cable is made from 304 stainless steel and supplied in a 100 ft length. It is designed for lifting and pulling tasks where corrosion resistance matters. The working load limit is 1152 lb with a breaking strength of 5760 lbf.
IWRC Core and Plain Ends
The rope uses a 19 x 7 strand classification with an independent wire rope core for structural stability. It is unlubricated and uncoated, leaving a plain silver finish. Both ends are plain cut, so termination hardware must be added before use.
Proposition 65 Compliance Notice
California Proposition 65 warnings apply because the product contains chemicals known to cause cancer and reproductive harm. Buyers needing food-grade or medically certified wire rope should verify suitability separately. No fittings, thimbles or lubrication are included in the bundle.
Highlights
- 1/4 in diameter suits compact rigging
- 304 stainless steel resists corrosion
- 19 x 7 strand construction balances flexibility and strength
- 1152 lb working load limit for lifting tasks
- 100 ft length covers extended runs
Specifications
| Brand | Dayton |
|---|
Questions about this item
What Working Load Limit does the 1/4 inch stainless steel cable support?
The cable has a Working Load Limit of 1152 lb and a breaking strength of 5760 lbf, so it is rated for lifting loads up to 1152 lb under normal use.
What diameter and length must the mounting hardware accommodate?
The cable measures 1/4 inch in diameter and comes in a 100 ft length, so any sheaves, clamps or terminations must fit that size.
How is the plain-end 19x7 IWRC wire rope terminated, and what mistake should be avoided?
The ends are plain with no factory fittings; install proper stainless-steel sleeves or clips matched to 1/4 inch 19x7 construction and torque them to spec — do not use undersized or mismatched hardware.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
