DataStor
DataStor H312C UHE 200W 4000 Hrs Projector Lamp
Genuine compatible Epson replacement lamp module with 200 W UHE bulb and housing, rated for 4,000 hours
- TypeUHE
- Wattage200W
- Lamp Life4,000 Hrs.
- Genuine Epson ELPLP58 replacement module fits directly
- UHE 200W bulb delivers 4000 hours of use
- Fully assembled housing enables quick tool-free installation
- Manufactured to ISO 9001 quality standards
- Compatible with Epson H312C projector models
Epson H312C UHE 200W Projector Lamp
This is a new replacement lamp module for Epson projectors using the H312C or ELPLP58 part number. It ships as a fully assembled bulb and housing for direct installation without additional tools or alignment steps.
Users with matching Epson models needing 200W UHE
Buyers whose projector requires a different wattage, base type, or lamp life should verify their service manual before ordering. The lamp is not suited for non-Epson hardware or for units specifying an alternative lamp code.
200 Watt UHE bulb rated for 4000 hours
The 200W UHE lamp delivers the specified brightness and rated lifespan for compatible Epson projectors. Confirm the 200W rating and 4000-hour life match your projector's requirements to ensure correct operation.
Highlights
- Genuine Epson ELPLP58 replacement module fits directly
- UHE 200W bulb delivers 4000 hours of use
- Fully assembled housing enables quick tool-free installation
- Manufactured to ISO 9001 quality standards
- Compatible with Epson H312C projector models
Specifications
| Brand | EPSON |
|---|---|
| Type | UHE |
| Wattage | 200W |
| Lamp Life | 4,000 Hrs. |
Questions about this item
Which Epson projector models accept the ELPLP58 lamp module that this H312C unit replaces?
The H312C lamp is built to the ELPLP58 specification, so it fits the Epson projectors that list ELPLP58 as their original lamp part number.
Can I reuse the existing lamp housing from my current ELPLP58 module, or must I swap the entire assembly?
This unit ships as a complete bulb-and-housing assembly, so you replace the whole module rather than only the bare bulb.
What on-screen indicator confirms the new lamp is recognised and the hour counter has reset?
After installation, open the projector menu and verify the lamp-hours counter reads zero, confirming the ELPLP58 module is detected and the timer has been reset.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



