DataStor Epson TW10H ELPLP29 UHE 130W 2000Hr projector lamp

Genuine-compatible Epson TW10H lamp

The DataStor Epson TW10H ELPLP29 module delivers a new UHE 130W bulb inside a pre-assembled housing. It is built for owners of compatible Epson projectors who need a drop-in replacement without sourcing separate parts. The lamp arrives ready to fit, saving the alignment steps required by bare-bulb kits. Buyers who want a bare bulb only or a different wattage should look elsewhere.

Pre-assembled housing for straightforward swap

Installation consists of removing the old module and sliding this complete unit into place, so no bulb-to-housing assembly is needed. The supplier notes that four version variants may be shipped depending on stock, which can cause confusion if the buyer expects a specific OEM source. Projectors with proprietary lamp-door interlocks or non-standard mounting tabs are not supported by this module.

2,000-hour rating at 130W output

The UHE lamp is rated for 2,000 hours of typical use at its 130W power level, providing a clear replacement interval for classroom or home-cinema schedules. Brightness will gradually decline as the lamp ages, and the 2,000-hour figure assumes standard operating modes rather than high-brightness settings. Users who run projectors continuously for days at a time or demand higher lumen output will reach the useful limit sooner.