DataStor
DataStor ELPLP87 215W UHE Projector Lamp
A 215 W UHE replacement lamp module rated for 5,000 hours, supplied as a complete housing for quick installation
- TypeUHE
- Wattage215W
- Lamp Life5,000 Hrs.
- Ready-to-install module saves setup time
- 215W UHE bulb matches original brightness
- 5,000-hour rated life reduces replacements
- ISO 9001 manufacturing ensures consistent quality
- Genuine compatible fits Epson PowerLite X24+
Genuine compatible replacement lamp
The DataStor ELPLP87 is a new UHE projector lamp module rated at 215 W and designed for the Epson PowerLite X24+. It arrives as a fully assembled bulb and housing so it can be installed immediately without additional tools or alignment steps. Buyers who need a bare bulb without the housing will not be served by this module.
ISO 9001 manufacturing and plug-in housing
Each unit is produced under ISO 9001 quality controls and tested for beam performance, ignition, voltage, connections and run-time before it leaves the factory. The complete housing means the connector mates directly with the projector’s socket, eliminating the risk of mis-seated lamps that can occur when only a bare bulb is swapped. Installers who prefer to reuse an existing cage must look elsewhere.
5 000-hour rated life at 215 W
The lamp is specified for 5 000 hours of operation at its rated 215 W power draw, giving a clear baseline for maintenance planning in classrooms or meeting rooms. Typical UHE designs run cooler than higher-wattage alternatives, so fan noise stays low during extended presentations. Users who require longer intervals between replacements should consider projectors that support higher-efficiency light sources.
Highlights
- Ready-to-install module saves setup time
- 215W UHE bulb matches original brightness
- 5,000-hour rated life reduces replacements
- ISO 9001 manufacturing ensures consistent quality
- Genuine compatible fits Epson PowerLite X24+
Specifications
| Brand | EPSON |
|---|---|
| Type | UHE |
| Wattage | 215W |
| Lamp Life | 5,000 Hrs. |
Questions about this item
What wattage does the ELPLP87 lamp draw, and what does that limit in use?
The lamp is rated at 215W, which sets the brightness ceiling and power draw for the projector it fits.
What housing and bulb assembly does the ELPLP87 include for mounting?
It arrives as a fully assembled 215W UHE bulb inside its housing, ready to slide into the projector's lamp compartment.
How is the ELPLP87 installed, and what step do people often miss?
Power off and cool the projector, open the lamp cover, remove the old module, insert the new ELPLP87 until it seats firmly, replace the cover, then reset the lamp timer in the menu.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
MADE IN USA TONER toner cartridge for KIP 7170 103 2 x 400 gm black
- Black
- Compatible



