DataStor
DataStor EB SXW18 Projector Lamp 215W UHE 5000 Hrs
Genuine compatible replacement lamp module with 215 W UHE bulb delivering 5,000 hours of projection life
- TypeUHE
- Wattage215W
- Lamp Life5,000 Hrs.
- Ready to install with pre-assembled housing
- UHE lamp technology rated at 215W power
- 5,000 hours rated lamp life for longevity
- Manufactured to ISO 9001 quality standards
- Genuine Epson ELPLP87 compatible replacement module
Epson EB SXW18 Replacement Lamp
This genuine compatible replacement lamp module fits the Epson EB SXW18 projector. It arrives as a fully assembled unit with the bulb already seated in its housing, so installation requires no separate handling of the lamp element. The product is supplied new and ready for immediate use.
Upgrades from a dim or expired original
When the projector's existing lamp reaches the end of its rated life or suffers a noticeable drop in brightness, this module restores the original light output. The change is worth it once image quality degrades enough to affect presentations or viewing, avoiding the cost of a full projector replacement.
Sustained output over 5,000 hours
The 215 W UHE bulb is rated for 5,000 hours of operation. Manufacturing follows ISO 9001 quality checks covering beam performance, ignition voltage, connections and run-time, so brightness and stability remain consistent throughout the rated lifespan rather than fading after a short burst.
Highlights
- Ready to install with pre-assembled housing
- UHE lamp technology rated at 215W power
- 5,000 hours rated lamp life for longevity
- Manufactured to ISO 9001 quality standards
- Genuine Epson ELPLP87 compatible replacement module
Specifications
| Brand | EPSON |
|---|---|
| Type | UHE |
| Wattage | 215W |
| Lamp Life | 5,000 Hrs. |
Questions about this item
Does the lamp housing fit the Epson EB-SXW18 projector without extra brackets?
The module is a fully assembled bulb and housing built for the Epson EB-SXW18, so it seats directly in the projector's lamp compartment with no additional brackets required.
What is the correct sequence for installing the ELPLP87 module, and where do people go wrong?
Power off and unplug the projector, let it cool, remove the lamp cover, loosen the retaining screws, pull the old module out by its handle, insert the new one until it clicks, retighten the screws, replace the cover, then reset the lamp timer in the menu; the step most often missed is resetting the timer.
How long before the 215 W UHE bulb needs replacement, and what indicates end of life?
Rated life is 5,000 hours; the projector will dim noticeably and eventually display a lamp-replacement warning when the bulb reaches that point.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



