CTLAMP
CTLAMP Replacement Projector Lamp SP-LAMP-037 for INFOCUS X15 X20 X21 X6 X7 X9 X9C
Replacement projector lamp module with housing fits Infocus X15, X20, X21, X6, X7, X9 and X9C, rated at 160 watts with up to 3000 hours life
- Ready-to-install lamp module with housing included
- 160 watt output matches original projector specification
- Up to 3000 hours rated lamp life
- Compatible with nine Infocus projector models
- 150 day warranty period covers the replacement
Compatible Projector Lamp Module
This CTLAMP replacement lamp module includes the bulb pre-installed in its housing for straightforward installation. It matches part number SP-LAMP-037 and fits INFOCUS X15, X20, X21, X6, X7, X9 and X9C projectors. The unit draws 160 Watts and is rated for up to 3000 hours of operation.
Suitable For Direct Replacement
Buyers needing a drop-in module for the listed INFOCUS models will find this unit matches the original form factor. It is not intended for projectors outside the X15, X20, X21, X6, X7, X9 or X9C series, nor for users who require only a bare bulb without the housing assembly.
Rated Output And Service Life
The 160 Watt lamp delivers brightness comparable to the original module and supports up to 3000 hours of typical use before replacement is needed. Heavy daily operation will reach this limit sooner, while occasional use extends the interval between changes.
Highlights
- Ready-to-install lamp module with housing included
- 160 watt output matches original projector specification
- Up to 3000 hours rated lamp life
- Compatible with nine Infocus projector models
- 150 day warranty period covers the replacement
Specifications
No published specifications for this item yet.
Questions about this item
Which InFocus projector models accept the SP-LAMP-037 lamp module?
The module fits InFocus X15, X20, X21, X6, X7, X9 and X9C projectors.
Can I install this 160-watt lamp in a projector that originally used a lower-wattage module?
Use the SP-LAMP-037 only in the listed InFocus models; the 160-watt rating matches the original specification for those units.
How do I confirm the new lamp is operating correctly after installation?
Reset the projector's lamp-hour counter, then verify the counter starts from zero and the image reaches full brightness.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



