We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black rectangular car amplifier with silver heatsink fins and terminal connectors

crunch

crunch Ground Pounder GP-1500.2 1500 Watt 2 Channel Amplifier 2 in 1 accessory

SKU CH-4K7E-88Z3G

A 2-channel car amplifier delivering 750 watts per channel at 2 ohms, 325 watts at 4 ohms, or 1500 watts bridged mono at 4 ohms with a 12 dB per octave crossover

  • Delivers 1,500 watts mono bridged at 4 ohms
  • Provides 750 watts per channel at 2 ohms stereo
  • Supplies 325 watts per channel at 4 ohms stereo
  • Operates in stereo, bridged mono, or both simultaneously
  • Variable electronic crossover at 12 dB per octave

1500-Watt Two-Channel Amplifier

The Crunch Ground Pounder GP-1500.2 delivers up to 1500 watts in bridged mono at 4 ohms. It provides 750 watts per channel at 2 ohms or 325 watts per channel at 4 ohms. The unit operates in stereo, bridged mono, or both modes simultaneously for flexible system design.

Installation Notes

Wiring must match the selected impedance and mode to avoid protection shutdowns. Bridged mono operation requires a 4-ohm minimum load; presenting a 2-ohm load in this mode will cause faults. The variable crossover is fixed at a 12 dB per octave slope and cannot be bypassed.

Pre-Order Checklist

Verify your speakers or subwoofers present the correct impedance for the chosen wiring mode. Confirm the vehicle electrical system can supply the current demanded by the selected power configuration. Ensure the 12 dB per octave crossover slope suits your intended frequency split.

Highlights

  • Delivers 1,500 watts mono bridged at 4 ohms
  • Provides 750 watts per channel at 2 ohms stereo
  • Supplies 325 watts per channel at 4 ohms stereo
  • Operates in stereo, bridged mono, or both simultaneously
  • Variable electronic crossover at 12 dB per octave

Specifications

No published specifications for this item yet.

Questions about this item

How can I confirm the amplifier is delivering its rated 1500 watts in bridged mono mode after installation?

With a 4-ohm load connected in bridged mono mode, play a steady test tone and measure AC voltage across the speaker terminals; the reading should correspond to the rated output.

What accessories are included with the Ground Pounder GP-1500.2 and what must I supply separately?

The package contains the amplifier only; you must provide power and ground cables, a remote turn-on lead, speaker wire, RCA interconnects and a suitable fuse holder.

Which operating mode should I select — stereo, bridged mono, or simultaneous stereo/bridged — for my speaker setup?

Use stereo mode for two 2-ohm loads needing 750 watts each, bridged mono for a single 4-ohm load needing 1500 watts, or simultaneous mode to run a 4-ohm sub on the bridged channel while powering two 4-ohm satellites at 325 watts each.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.