We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular silver car amplifier with black end caps and visible screw terminals

crunch

crunch Ground Pounder GP-1000.2 1000W 2-Channel Car Amplifier

SKU CH-DE85-6HZDX

Delivers up to 1000 watts across two channels with stereo, bridged mono, or simultaneous operation and a variable 12 dB per octave crossover

  • TypeAmplifiers
  • Amplifier Channels2 Channels
  • Max Power1000W
  • Delivers 1000 watts maximum power for strong bass output
  • Provides 500 watts per channel at 2 ohms for loud, clean sound
  • Supports 250 watts per channel at 4 ohms for flexible speaker matching
  • Bridges to a single 1000 watt mono channel for subwoofer power
  • Runs stereo, bridged mono, or both simultaneously for system versatility

Ground Pounder GP-1000.2 1000W Amplifier

The Crunch Ground Pounder GP-1000.2 is a 1000W two-channel car amplifier built for drivers who want strong bass and clear output from a stereo or bridged mono setup. It delivers 500 watts per channel at 2 ohms, 250 watts per channel at 4 ohms, and 1000 watts in bridged mono at 4 ohms. The Class AB design supports stereo, bridged mono, or simultaneous stereo and bridged operation.

Variable Crossover and Protection LEDs

A variable electronic crossover with a 12 dB per octave slope lets you tune the frequency response to match your speakers or subwoofers. Nickel-plated RCA preamp inputs resist corrosion while screw-down connectors secure power and speaker wires. Built-in diagnostics LEDs on the end panel show overload and speaker short status at a glance.

Suits Single-Amp Systems.

This amplifier suits owners powering a subwoofer pair or a component set from one chassis. Buyers needing more than two channels for front, rear, and centre speakers should look elsewhere. The 2-ohm stereo rating also means it works with low-impedance loads that some smaller amps cannot drive.

Highlights

  • Delivers 1000 watts maximum power for strong bass output
  • Provides 500 watts per channel at 2 ohms for loud, clean sound
  • Supports 250 watts per channel at 4 ohms for flexible speaker matching
  • Bridges to a single 1000 watt mono channel for subwoofer power
  • Runs stereo, bridged mono, or both simultaneously for system versatility

Specifications

TypeAmplifiers
Amplifier Channels2 Channels
Max Power1000W

Questions about this item

How often will the fuse on the GP-1000.2 need checking or replacement under normal use?

The amplifier includes overload and speaker-short protection with diagnostic LEDs that light when a fault occurs; inspect the fuse only if a protection LED illuminates.

At what output level does the 12 dB per octave crossover start limiting the signal during extended play?

The variable electronic crossover rolls off at 12 dB per octave above the frequency you set, so the limit appears at the chosen crossover point rather than at a fixed power level.

How hot does the Class AB chassis get and does the fan noise increase after several hours at 500 watts per channel?

The amp uses a Class AB design with system-diagnostic LEDs for overload monitoring; no fan specification or thermal-throttle threshold is provided in the product data.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.