We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two RG59 coaxial F crimp connectors with ferrules

CONNECT IT

CONNECT IT F-59AHX 2 Pack RG59 Coaxial F Crimp Connector

SKU CH-TCS1-6DMHM

Two crimp-on F connectors with attached half-inch ferrules terminate RG59 coaxial cable for video use

  • TypeRG59 Coaxial "F" Crimp On End Connector
  • Two connectors per pack for multiple terminations
  • RG59 coaxial compatibility ensures proper signal fit
  • Crimp-on design creates secure permanent connection
  • Included half-inch ferrule simplifies cable preparation

Two-pack RG59 F-type crimp connectors

This two-pack supplies CONNECT IT F-59AHX connectors that terminate bare RG59 coaxial cable with a standard F-type interface. Each unit includes an attached half-inch ferrule for a secure crimp connection. The parts are intended for video cable runs that use RG59 coax.

Simple crimp install; wrong cable fails

Installation requires a coaxial stripper and a crimp tool sized for the supplied ferrule; push the prepared cable home and compress the ferrule fully. Using cable other than RG59 prevents a gas-tight seal and causes signal loss or intermittent picture. No soldering or compression fittings are involved.

Highlights

  • Two connectors per pack for multiple terminations
  • RG59 coaxial compatibility ensures proper signal fit
  • Crimp-on design creates secure permanent connection
  • Included half-inch ferrule simplifies cable preparation

Specifications

BrandCONNECT IT
ModelF-59AHX
TypeRG59 Coaxial "F" Crimp On End Connector

Questions about this item

How can I verify the F-59AHX connector is properly crimped onto my RG59 cable?

After crimping, the centre pin should sit flush with the dielectric and the ferrule must grip the outer jacket firmly; a gentle tug should not pull the connector free.

The pack contains two F-59AHX connectors — do I need any extra ferrules or tools?

Each connector includes its attached 1/2" ferrule, so no separate ferrules are required; you will need a coaxial crimp tool sized for RG59.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.