We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass angle stop valve with slip joint connection

CONCORD

CONCORD CC44102DL 1/2" FIP X 1/2" X 7/16" Slip Joint Angle Stop

SKU CH-DTKK-6TDWH

A 1/2" FIP inlet angle stop with 1/2" and 7/16" slip-joint outlets for supply-line connections

  • TypeTools
  • 1/2" FIP inlet connects directly to supply line
  • 1/2" x 7/16" slip joint outlet fits standard risers
  • Angle-stop design allows shut-off at fixture
  • Brass construction resists corrosion for long service life
  • California Proposition 65 warning applies to this product

Concord Angle Stop Valve

The Concord CC44102DL is a 1/2 inch FIP by 1/2 inch by 7/16 inch slip joint angle stop designed for residential plumbing supply lines. It connects a female iron pipe inlet to a compression outlet for fixture shut-off control. This new brass component suits homeowners and plumbers completing bathroom or kitchen rough-in work. It is not for installers needing sweat, push-fit or PEX barb connections.

Thermals Noise Power

As a passive mechanical valve the angle stop generates no heat, produces no audible noise and draws zero electrical power during normal operation. Water flow and pressure are governed entirely by the supply system and fixture demand. No external energy source or active cooling is required for daily use.

Build Quality Connectors

The brass body provides corrosion resistance for potable water service and the slip joint nut allows tool-free connection to 7/16 inch supply tubes. Quarter-turn handle operation gives positive shut-off with minimal effort. California Proposition 65 warnings apply because the product contains chemicals known to the state to cause cancer and birth defects or other reproductive harm.

Highlights

  • 1/2" FIP inlet connects directly to supply line
  • 1/2" x 7/16" slip joint outlet fits standard risers
  • Angle-stop design allows shut-off at fixture
  • Brass construction resists corrosion for long service life
  • California Proposition 65 warning applies to this product

Specifications

BrandCONCORD
TypeTools

Questions about this item

How do I install the 1/2" FIP inlet on the CC44102DL angle stop, and what step is often missed?

Thread the 1/2" FIP inlet onto the supply pipe using pipe tape or sealant; the step often missed is fully tightening the slip-joint nut onto the 7/16" outlet after the ferrule seats.

What maintenance or replacement will the CC44102DL angle stop need over time?

Replace the internal washer or O-ring if dripping appears at the stem; the slip-joint ferrule may also need replacement if the 7/16" connection leaks.

What limit appears first on the CC44102DL under sustained household water pressure?

The brass body and slip-joint seal are rated for normal residential pressure; the first limit is typically washer wear causing a slow drip at the stem.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.