We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with black memory chips, gold edge connector, small rectangular stick

Computer Memory Solutions

Computer Memory Solutions 8GB DDR3L 1600MHz SODIMM for Foxconn Nanopc At-5570 Nt-A3800 memory upgrade

SKU CH-GA1J-83W8Z

8GB DDR3L 1600MHz SODIMM module for Foxconn NanoPC AT-5570 and nT-A3800 systems

  • Capacity8GB
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Timing11-11-11
  • Voltage1.35V
  • 8 GB capacity expands multitasking headroom on Foxconn NanoPC AT-5570 and NT-A3800
  • DDR3L 1600 MHz CL11 timing keeps latency low for responsive everyday workloads
  • 35 V low-voltage operation reduces power draw and heat in compact systems
  • 204-pin SODIMM form factor fits the single expansion slot without adapters
  • 2Rx8 rank organisation with major-brand chips delivers stable compatibility guaranteed by CMS

Foxconn NanoPC 8GB DDR3L SODIMM

This 8GB DDR3L 1600MHz SODIMM is built for the Foxconn NanoPC AT-5570 and nT-A3800. It runs at 1.35V with CL11 timing and uses a 204-pin unbuffered design. The single module fills one expansion socket in these compact systems.

Replacing factory 4GB modules

The board accepts a maximum of 8GB across one socket, so this stick completes the upgrade path. If 4GB is already installed, the system may only recognise 3.5GB or less depending on configuration. A 64-bit operating system is required to address the full capacity.

Suits NanoPC owners needing maximum memory

This module suits owners of the listed Foxconn NanoPC models who want the highest supported RAM. Builders with other platforms, systems requiring ECC or registered memory, or anyone needing more than 8GB should look elsewhere.

Highlights

  • 8 GB capacity expands multitasking headroom on Foxconn NanoPC AT-5570 and NT-A3800
  • DDR3L 1600 MHz CL11 timing keeps latency low for responsive everyday workloads
  • 35 V low-voltage operation reduces power draw and heat in compact systems
  • 204-pin SODIMM form factor fits the single expansion slot without adapters
  • 2Rx8 rank organisation with major-brand chips delivers stable compatibility guaranteed by CMS

Specifications

BrandComputer Memory Solutions
ModelCM10246412800SODRL
Capacity8GB
Type204-Pin DDR3 SO-DIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Timing11-11-11
Voltage1.35V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemFoxconn Nanopc At-5570, Nanopc Nt-A3800
Package Content1 Memory RAM Stick

Questions about this item

Will this 204-pin SODIMM fit the single memory slot in my Foxconn NanoPC AT-5570 or NT-A3800?

Yes, it is a 204-pin DDR3L SODIMM built for those systems, which have one SO-DIMM socket supporting up to 8 GB.

What is the correct way to seat this module so the system recognises the full 8 GB?

Align the notch with the slot key, insert the stick at an angle until the gold contacts are fully hidden, then press down evenly until both side clips snap into the notches; a partial seat can leave the capacity at 3.5 GB or less.

Does this unbuffered, non-ECC stick need any firmware updates or matching pairs to run reliably over time?

No, it runs as a single 2Rx8 rank at 1.35 V with CL11 timing; no pairing or BIOS flashing is required, and the major-brand chips are rated for continuous operation.

New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.

More in System Specific Memory

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.