We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Clear plastic 8mm two-pin strip connectors with 6.6ft 20AWG extension wires, twenty pieces

COB 8mm 2 Pin Transparent Connector 20 Pack 6.6FT 20AWG Extension Wires

SKU CH-W4KT-X9NXX

Twenty 8 mm transparent press-fit connectors and a 6.6 ft 20 AWG extension wire join single-colour COB strips without soldering

  • Solder-free setup with press-fit connectors for quick DIY installs
  • Gapless 8 mm fit ensures stable contact on COB strips
  • 6 ft 20 AWG extension wires included for flexible runs
  • Transparent housing shows connection points for easy inspection
  • 20-piece pack covers multiple corners and splices in one kit

COB 8mm 2-Pin Connectors for PWM Strips

This 20-pack of transparent connectors is made for PWM single-colour COB strips with an 8 mm width. The press-fit design gives a gapless, stable link without soldering. DIY installers and lighting hobbyists can join or extend strips quickly. Buyers who need connectors for wider RGB or addressable strips cannot use this kit.

Low-Voltage Wiring with 20 AWG Extension

The included 6.6 ft (200 cm) 20 AWG extension wires carry the low currents typical of single-colour COB lighting. No active cooling or power supply is part of the kit, so heat and noise are negligible in normal use. Power draw depends entirely on the attached strip length and controller. Installers running very long daisy-chained runs should verify voltage drop separately.

Twenty Connectors Plus One Extension Wire

The package supplies twenty 2-pin strip-to-strip connectors and a single 6.6 ft extension wire. The transparent housings avoid blocking light at corners or splices. No software, drivers or additional tools are bundled. Users who need multiple extension wires or right-angle adapters must source them elsewhere.

Highlights

  • Solder-free setup with press-fit connectors for quick DIY installs
  • Gapless 8 mm fit ensures stable contact on COB strips
  • 6 ft 20 AWG extension wires included for flexible runs
  • Transparent housing shows connection points for easy inspection
  • 20-piece pack covers multiple corners and splices in one kit

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 8mm 2-pin connectors on a COB strip without soldering, and what step causes poor contact?

Press each connector straight onto the strip's copper pads until the internal clips click; the common mistake is angling the connector, which leaves one pin floating and creates flicker.

What maintenance or replacement will the 20AWG extension wires need after extended use?

Inspect the wire insulation and connector pins every few months; replace any wire that shows cracking or a connector that no longer grips the strip firmly.

What limit appears first when the 6.6 ft 20AWG wires run a COB strip continuously at full brightness?

Voltage drop along the 20AWG conductors becomes noticeable first, causing the far end of the strip to dim compared with the section near the power feed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.