Cleveland
Cleveland Jobber Drill V Vanadium HSS 73091 pneumatic accessory
Jobber-length drill bit in vanadium high-speed steel with TiCN coating, 118-degree conventional point, .3770 decimal equivalent, letter size V
- TypeDrill Accessories
- MaterialHAWA
- V-size drill bit for precise 0.3770 inch holes
- 118-degree conventional point starts cleanly without walking
- Vanadium high-speed steel resists wear in tough materials
- TiCN coating extends cutting life and reduces friction
Cleveland V-Series Jobber Drill Bit
The Cleveland V-series jobber drill bit is machined from vanadium high-speed steel with a TiCN coating for extended wear resistance. Its 118-degree conventional point suits general-purpose drilling in ferrous and non-ferrous metals. The letter-size V diameter equals .3770 inches decimal equivalent. This accessory fits standard drill chucks used in maintenance and fabrication shops.
Practical limits of the 118-degree conventional
The 118-degree point angle centres quickly but can wander on very hard or work-hardened alloys without a pilot hole. TiCN coating reduces friction yet does not replace coolant when drilling deep holes or tough stainless grades. The jobber-length flute clears chips adequately for through-holes up to moderate depth, but deep blind holes may need peck cycles. Buyers needing coolant-through capability or split-point self-centring on abrasive materials should select a different drill geometry.
Highlights
- V-size drill bit for precise 0.3770 inch holes
- 118-degree conventional point starts cleanly without walking
- Vanadium high-speed steel resists wear in tough materials
- TiCN coating extends cutting life and reduces friction
Specifications
| Brand | Cleveland |
|---|---|
| Type | Drill Accessories |
| Material | HAWA |
Questions about this item
Should I choose the V size or a different letter size for my application?
The V size has a decimal equivalent of .3770 inches; match that exact diameter to the hole your job requires.
What does the 118-degree point angle mean when the bit is in a drill?
A 118-degree conventional point centres quickly in steel and works well for general-purpose drilling without a pilot hole.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
