Cleveland Golf
Cleveland Golf End Mill HSS TiCN 3/16 4 FL SGL Sq End
A 3/16-inch four-flute high-speed steel square end mill with a TiCN finish for finishing operations
- TypeHole, Drill, Bore & Wire Gauges
- TiCN coating extends tool life
- Four-flute design improves finish quality
- 3/16 inch diameter suits precision milling
- 30-degree helix angle aids chip evacuation
- High-speed steel construction handles general-purpose work
General-purpose finishing end mill
This Cleveland Golf square end mill is made from high-speed steel with a TiCN coating for general-purpose finishing work. The fractional-inch cutter has a 3/16-inch milling diameter, four flutes, and a single-end design. It suits machinists and fabricators who need a standard right-hand cutting tool for light production or maintenance milling.
Cutting geometry and material limits
The 30-degree helix angle and zero corner radius produce a sharp square profile for finishing passes in steel, cast iron, and non-ferrous metals. High-speed steel substrate limits cutting speeds compared with carbide, so the tool works best on manual or lower-rpm machines where toughness outweighs maximum feed rates. TiCN finish adds wear resistance but does not change the base material constraints.
Straightforward holder fitment
A 3/8-inch shank fits common collets and end-mill holders without adapters. Overall length of 2-3/8 inches and 1/2-inch length of cut keep overhang short for rigidity. The main installation issue is excessive run-out from worn collets, which accelerates flank wear on the HSS flutes. Verify holder condition before use.
Highlights
- TiCN coating extends tool life
- Four-flute design improves finish quality
- 3/16 inch diameter suits precision milling
- 30-degree helix angle aids chip evacuation
- High-speed steel construction handles general-purpose work
Specifications
| Brand | Cleveland |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
Should I pick the 3/16 inch diameter with 1/2 inch cut length or a different size?
Choose the 3/16 inch diameter and 1/2 inch cut length when your slot or pocket matches those dimensions; the 3/8 inch shank fits standard holders for this size.
What does the 30 degree helix angle do when the tool is cutting?
The 30 degree helix gives a balanced chip flow and smooth finish on general-purpose materials without excessive vibration.
How does the TiCN coating affect tool life and cutting speed?
TiCN coating increases hardness and heat resistance, allowing higher speeds and longer life than uncoated high-speed steel in finishing passes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
