Cleveland
Cleveland C75386 4-Flute HSS Corner Rounding End Mill Bright
A 4-flute HSS corner rounding end mill with a Weldon flat for secure tool holding
- TypeMilling
- 4-flute design gives smoother corner rounding cuts
- High-speed steel construction resists wear during milling
- Bright uncoated finish suits general-purpose machining
- Weldon flat shank locks securely in tool holders
- Cleveland brand trusted for reliable cutting tools
Cleveland C75386 Corner Rounding End Mill
The Cleveland C75386 is a single corner rounding end mill designed for milling operations that require a smooth radius on workpiece edges. It suits machinists and maintenance technicians who need a dedicated profiling tool for general-purpose shop tasks.
Four-flute high-speed steel construction
The cutter uses a four-flute high-speed steel body and an uncoated bright finish to handle a range of ferrous and non-ferrous materials. Its Weldon flat shank locks securely into standard end-mill holders, eliminating the need for collets or shrink-fit adapters in typical milling setups.
Uncoated bright finish reduces built-up edge
Without a coating, the bright surface resists material adhesion when cutting aluminium, brass or mild steel, so the radius stays true and secondary finishing passes are often unnecessary. The tool arrives ready to use with no additional accessories or software required.
Highlights
- 4-flute design gives smoother corner rounding cuts
- High-speed steel construction resists wear during milling
- Bright uncoated finish suits general-purpose machining
- Weldon flat shank locks securely in tool holders
- Cleveland brand trusted for reliable cutting tools
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
How much corner radius can the 75386 end mill produce before the flute length limits the cut?
The cutter is designed for a 1-1/2 inch corner radius; the flute length determines the maximum depth of cut in a single pass.
Does the uncoated high-speed steel body run hot enough to require coolant during continuous profiling?
Uncoated HSS generates more heat than coated tools, so flood coolant or mist is recommended for sustained corner-rounding operations.
Will the Weldon flat on the shank fit directly into my existing ER collet holder?
No, a Weldon flat requires a side-lock or Weldon-style holder; an ER collet chuck will not clamp the flat securely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
