Cleveland
Cleveland C75098 10 mm 4-Flute HSS Square End Mill
10 mm diameter HSS square end mill with 25.4 mm cut length, 9.52 mm Weldon shank and 68.26 mm overall length
- TypeMilling
- 10 mm milling diameter for precise material removal
- Four-flute high-speed steel construction for smooth cutting performance
- Center-cutting design enables plunge and profile milling
- 4 mm length of cut supports deeper passes
- 52 mm Weldon-shank diameter fits standard tool holders
Cleveland C75098 10 mm Square End Mill
The Cleveland C75098 is a 10 mm square end mill made from high speed steel with an uncoated finish. It features four flutes and a center cutting design for versatile milling operations. The tool uses a Weldon flat shank measuring 9.52 mm in diameter for secure holding. It suits general purpose machining in a workshop environment.
Thermals noise and power draw
Heat generation depends on the spindle speed, feed rate and workpiece material rather than the tool itself. An uncoated high speed steel cutter runs hotter than coated alternatives when used in difficult alloys. Proper coolant or air blast manages temperature and chip evacuation during extended cuts. Power consumption is determined by the machine tool and cutting parameters selected.
25.4 mm length of cut decides the application
The 25.4 mm flute length sets the maximum depth of cut in a single pass for this 10 mm diameter tool. Shallow pockets or profiles within this limit are straightforward; deeper features require multiple steps or a longer series cutter. Overall length is 68.26 mm so check machine clearance before ordering. The shank diameter of 9.52 mm must match your tool holder or collet specification.
Highlights
- 10 mm milling diameter for precise material removal
- Four-flute high-speed steel construction for smooth cutting performance
- Center-cutting design enables plunge and profile milling
- 4 mm length of cut supports deeper passes
- 52 mm Weldon-shank diameter fits standard tool holders
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
How do I install the 10 mm end mill with its Weldon flat, and what step is often missed?
Insert the 9.52 mm shank into a Weldon-compatible holder, align the flat with the set screw, and tighten firmly — the step often missed is verifying the flat seats fully against the screw before cutting.
What maintenance or replacement will the uncoated high-speed steel 4-flute cutter need later?
The uncoated HSS flutes will dull with use; plan to resharpen or replace the 10 mm cutter once edge wear degrades finish quality on your workpiece.
What limit appears first during sustained cutting with this 25.4 mm length of cut?
Heat buildup in the uncoated high-speed steel typically becomes the limiting factor before tool deflection, especially in deeper slots at full 25.4 mm engagement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
