Cleveland
Cleveland C61859 4-Flute Carbide Square End Mill
A 4-flute carbide square end mill with a 0.296875 in milling diameter and 0.875 in length of cut
- TypeMilling
- 4-flute carbide design enables smooth multi-material milling
- 296875 in diameter suits precision slotting and profiling tasks
- 875 in length of cut supports deeper single-pass engagement
- 5/16 in shank fits standard ER collets and holders
- Uncoated carbide substrate resists built-up edge in non-ferrous alloys
Cleveland C61859 Carbide Square End Mill
This Cleveland C61859 is a new 4-flute carbide square end mill built for general-purpose milling. It features a 0.296875 in milling diameter, a 5/16 in shank diameter, and a straight shank design. The uncoated carbide construction suits a range of materials without coolant-through requirements.
Suited For General-Purpose Milling Tasks
This tool suits machinists and fabricators performing standard slotting, profiling, or plunging operations in ferrous or non-ferrous metals. The 0.875 in length of cut and 2-1/2 in overall length fit typical job-shop setups. It is not for buyers needing coolant-through capability, coated tooling for high-heat alloys, or a necked design for deep-reach cavities.
Verify Shank And Holder Compatibility
Before ordering, confirm your tool holder accepts a 5/16 in straight shank and that the 0.296875 in cutting diameter matches your programmed tool path. Check that the 2-1/2 in overall length clears your workpiece and fixture without interference. Ensure your machine and setup can run an uncoated carbide tool at appropriate speeds and feeds for the material.
Highlights
- 4-flute carbide design enables smooth multi-material milling
- 296875 in diameter suits precision slotting and profiling tasks
- 875 in length of cut supports deeper single-pass engagement
- 5/16 in shank fits standard ER collets and holders
- Uncoated carbide substrate resists built-up edge in non-ferrous alloys
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
What shank diameter must my tool holder accept for the Cleveland C61859 end mill?
The end mill has a 5/16 in shank diameter, so your collet or holder must grip that size.
Will the 0.875 in length of cut reach the full depth of my existing workpiece?
The flute length is 0.875 in; it will cut to that depth in a single pass, deeper cuts need multiple passes.
How can I confirm the mill is cutting correctly after installation?
Check for even chip formation, consistent sound and a smooth square-bottomed slot matching the 0.296875 in diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
