Cleveland
Cleveland C61062 2-Flute Carbide Square End Mill .625 in pneumatic accessory
A 2-flute carbide square end mill with a .625 in diameter and 1.25 in length of cut for general-purpose milling
- TypeMilling
- Cuts cleanly with two-flute carbide geometry
- 625 in diameter suits medium milling tasks
- 25 in length of cut handles deeper passes
- Uncoated carbide works well on non-ferrous metals
- 3 1/2 in overall length fits standard tool holders
Cleveland C61062 End Mill
The Cleveland C61062 is a 2-flute carbide square end mill designed for general-purpose milling operations. It features a 0.625 inch cutting diameter with a matching 5/8 inch shank for direct tool holder compatibility. The solid carbide construction provides high rigidity and wear resistance for production environments.
General-purpose milling in ferrous
This tool suits machinists performing slotting, profiling, and plunge cuts where an uncoated carbide substrate is preferred. It is not intended for high-temperature alloys or hardened steels requiring specialised coatings. Operations needing internal coolant delivery or extended reach beyond the standard length should evaluate alternative tooling.
0.625 inch diameter with 1.25 inch length of cut
The cutting diameter and flute length define the maximum radial engagement and axial depth per pass. The 3-1/2 inch overall length sets the gauge line projection for tool changer clearance. Verify these dimensions against your workpiece geometry and machine envelope before selection.
Highlights
- Cuts cleanly with two-flute carbide geometry
- 625 in diameter suits medium milling tasks
- 25 in length of cut handles deeper passes
- Uncoated carbide works well on non-ferrous metals
- 3 1/2 in overall length fits standard tool holders
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
What shank diameter does the Cleveland C61062 end mill require in the tool holder?
The shank diameter is 5/8 in, matching the .625 in milling diameter, so it fits a standard 5/8 in collet or end-mill holder without an adapter.
How should the uncoated carbide flutes be engaged during installation to avoid premature wear?
Clamp the 5/8 in shank fully into the holder, set the spindle speed for carbide, and use a rigid setup; the straight, non-coolant-through design means chips must be cleared by air blast or flood coolant from outside.
When will the 1.25 in length of cut on this square end mill need to be replaced?
Replace the tool when flank wear on the two carbide flutes reaches the manufacturer’s wear limit or when the 1.25 in cutting length no longer produces the required finish on the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
