Cleveland
Cleveland C61058 2-Flute Carbide Square End Mill .5 in pneumatic accessory
A 0.5-inch diameter carbide square end mill with a 1.5-inch length of cut and 6-inch overall length for general-purpose milling
- TypeMilling
- Solid square-end profile for clean corner milling
- Two-flute carbide construction for efficient chip evacuation
- 5 in length of cut for deep pocketing
- .5 in shank fits standard holders
- Uncoated surface for general-purpose use
Cleveland C61058 2-Flute Carbide End Mill
The Cleveland C61058 is a solid carbide square end mill designed for general-purpose milling tasks. Its uncoated construction suits operators who prefer to apply their own coatings or run specific materials dry. The half-inch shank diameter matches standard tool holders for direct mounting.
Sustained-load behaviour
Two flutes provide wide chip gullets that evacuate material efficiently during extended cuts. The uncoated carbide surface resists thermal cycling when feed rates are kept consistent. A 1.5 inch length of cut allows deep pocketing without requiring tool changes mid-operation.
Upgrade path
This tool replaces worn high-speed steel end mills when longer tool life and higher cutting speeds are required. The step up is justified when machining abrasive alloys or when repeatable dimensional accuracy outweighs the higher initial cost of carbide.
Highlights
- Solid square-end profile for clean corner milling
- Two-flute carbide construction for efficient chip evacuation
- 5 in length of cut for deep pocketing
- .5 in shank fits standard holders
- Uncoated surface for general-purpose use
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
How much heat does the 0.5 in carbide end mill generate during extended milling runs?
Carbide dissipates heat well, but prolonged cuts in tough material will warm the tool; use appropriate feeds, speeds and coolant breaks to manage temperature.
What shank size must my milling machine or CNC spindle accept to hold this 1/2 in shank end mill?
The tool has a 1/2 in straight shank, so the machine needs a 1/2 in collet, end-mill holder or shrink-fit chuck that matches that diameter.
Will this 2-flute square end mill work effectively on the older manual knee mill I still use?
Yes, the straight 1/2 in shank fits standard tooling on manual knee mills, and the 2-flute geometry suits both profile and slotting cuts on that equipment.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
