Cleveland
Cleveland C60172 2-Flute Carbide Square Double-End GP End Mill
A 0.125-inch carbide square end mill with a 0.375-inch cut length and double-end design for general-purpose milling
- TypeMilling
- 125 in carbide cutter handles fine detail work
- Double-ended square design gives two fresh cutting edges
- 375 in length of cut reaches shallow pockets
- 3/8 in Weldon shank locks securely in standard holders
- Uncoated carbide resists built-up edge in non-ferrous metals
Double-End Carbide End Mill
The Cleveland C60172 is a 2-flute square end mill made from solid carbide. It suits machinists and maintenance teams needing a general-purpose cutter for slotting and profiling in a variety of materials.
0.125 in diameter with 0.375 in length of cut
The cutting diameter is .125 in and the length of cut is .375 in. The double-end design provides two usable cutting ends per tool, extending tool life before replacement. The uncoated carbide substrate performs well in non-ferrous and softer materials where coatings add no benefit.
3/8 in Weldon shank fits standard holders
The shank diameter is 3/8 in with a Weldon flat for secure clamping in standard end mill holders. The overall length is 3 in, allowing access to shallow pockets without excessive overhang. The tool is non-coolant-through, so external flood or mist coolant must be supplied by the machine setup.
Highlights
- 125 in carbide cutter handles fine detail work
- Double-ended square design gives two fresh cutting edges
- 375 in length of cut reaches shallow pockets
- 3/8 in Weldon shank locks securely in standard holders
- Uncoated carbide resists built-up edge in non-ferrous metals
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
Will the .125 in milling diameter and .375 in length of cut work with my older 3/8 in collet setup?
The 3/8 in shank diameter and Weldon flat match standard 3/8 in collets and holders, so the cutter fits directly without adapters.
How can I confirm the uncoated carbide end mill is cutting correctly after installation?
Expect clean, square-bottom slots at the .125 in diameter with minimal chatter when run at appropriate speeds for carbide tooling.
Does the double-end C60172 include any holders or coolant accessories in the box?
Only the end mill itself is supplied; holders, collets and coolant components must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
