Cleveland
Cleveland C60070 4-Flute Carbide HP VI Corner Radius End Mill
Four-flute carbide corner-radius end mill with a .625 in diameter, .125 in radius, 2.25 in flute length and 5 in overall length
- TypeMilling
- Precise corner profiling with 0.125 in radius
- 4-flute carbide core resists wear in heavy cuts
- 625 in diameter suits standard inch tooling
- 25 in flute length reaches deep cavities
- 5 in overall length provides rigid spindle grip
Cleveland C60070 Carbide End Mill
The Cleveland C60070 is a 4-flute carbide end mill featuring a corner radius profile. It is designed for high-performance milling operations requiring wear resistance and precise corner geometry. The uncoated carbide substrate suits general-purpose machining across various materials. This tool targets machinists and shops needing reliable contouring and profiling capability.
Suited for corner-radius profiling
This tool suits machinists performing contouring, pocketing, or profiling where a defined corner radius is required. The four-flute design supports efficient material removal in suitable workpiece materials. Builders needing ball-nose geometry for 3D surfacing or tools with specific coating technologies for high-temperature alloys should evaluate alternative cutter styles.
Uncoated carbide substrate
The uncoated carbide construction provides baseline hardness and heat resistance without specialised surface treatments. This allows the cutter to be applied across a range of standard milling tasks where coating adhesion or chemistry is not a deciding factor. The corner radius of .125 in helps reduce chipping at the flute intersection during corner engagement.
Highlights
- Precise corner profiling with 0.125 in radius
- 4-flute carbide core resists wear in heavy cuts
- 625 in diameter suits standard inch tooling
- 25 in flute length reaches deep cavities
- 5 in overall length provides rigid spindle grip
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
What milling machine spindle taper or collet size do I need to hold the .625 in shank of the C60070?
The C60070 has a .625 in straight shank, so you need a .625 in collet or an end-mill holder with a matching .625 in bore.
Can I run the uncoated carbide C60070 at the same feeds and speeds I used for my old HSS corner-radius cutters?
No — uncoated carbide is more brittle than HSS; reduce feed per tooth and increase spindle speed to avoid chipping the .125 in corner radius.
How do I verify the C60070 is cutting correctly after I install it?
Check for a clean .125 in corner radius on the workpiece, consistent chip load across all four flutes, and no chatter marks on the 2.25 in length of cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
