Cleveland
Cleveland C54758 Straight Flute Hand Tap M14-2.00
Straight-flute hand tap cuts M14 × 2.00 metric threads in high-speed steel with four flutes and a D7 limit for a 6H fit
- TypeTaps
- Cuts M14×2.00 metric threads in through-holes
- Four-flute high-speed steel removes chips cleanly
- 75 % thread engagement with 12.00 mm drill
- 3 19/32 in overall length reaches deep holes
- Bright uncoated finish resists galling in steel
Cleveland M14-2.00 Hand Tap Kit
This three-piece set contains straight-flute hand taps for cutting M14 threads with a 2.00 mm pitch. Each tap is made from high-speed steel with a bright, uncoated finish. The right-hand thread design follows a 6H class of fit and a D7 thread limit. Four flutes provide chip clearance during manual threading operations.
Suited for manual thread cutting and repair
These taps are intended for hand use in maintenance, repair and light production work where a machine tap is not required. The 75 percent thread drill size of 12.00 mm prepares the correct hole for the M14-2.00 thread form. Builders needing powered tapping, coated tools for abrasive materials or larger thread diameters should select a different product.
Thread size M14-2.00 metric coarse
The nominal diameter of 14 mm and pitch of 2.00 mm define every other dimension in the kit, including the 1 21/32 in thread length and 3 19/32 in overall length. Confirm that the workpiece material and hole size match this specification before starting the cut.
Highlights
- Cuts M14×2.00 metric threads in through-holes
- Four-flute high-speed steel removes chips cleanly
- 75 % thread engagement with 12.00 mm drill
- 3 19/32 in overall length reaches deep holes
- Bright uncoated finish resists galling in steel
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Taps |
Questions about this item
Will the M14-2.00 tap work with my existing 12.00 mm drill bits for 75 percent thread engagement?
Yes, the specified 75 percent thread drill size is 12.00 mm, matching standard drill bits you likely already own.
How can I confirm the tap is cutting a correct 6H class of fit after setup?
Check the finished thread with a 6H go/no-go gauge; the go gauge should enter fully and the no-go should stop within three turns.
Does the C54758 kit include all three taps or must I buy the taper and bottoming taps separately?
The three-piece kit supplies taper, plug and bottoming taps together; no additional taps are required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
