Cleveland
Cleveland C42084 2-Flute HSS Square Double End Mill Bright
High-speed steel double-end mill with .875 in diameter and 1.5625 in length of cut for general milling tasks
- TypeDrill Mills
- 2-flute design for efficient chip clearance and smooth milling
- .875 in cutting diameter for precise slot and profile work
- High-speed steel construction for durability in general-purpose machining
- Bright uncoated finish suited for non-ferrous and low-carbon steels
- Double-end configuration provides two cutting ends per tool
Cleveland C42084 Double End Mill
This Cleveland C42084 is a 2-flute high-speed steel square double end mill designed for general milling operations. The bright, uncoated finish suits dry machining in softer materials where coolant is not used. It serves machinists and maintenance teams needing a versatile cutter for slotting, profiling and keyway work.
Weldon Flat Shank And Bright HSS
The 7/8 in Weldon flat shank locks securely into standard end mill holders, preventing pull-out during heavy cuts. High-speed steel construction provides good toughness for interrupted cuts and can be resharpened multiple times to extend tool life. The non-coolant-through design means chips must be cleared by external air blast or flood coolant from the machine.
Verify Shank And Diameter Compatibility
Confirm your tool holder accepts a 7/8 in Weldon shank before ordering. The .875 in cutting diameter and 1.5625 in length of cut define the maximum slot width and depth in a single pass. Buyers needing longer reach, coated performance for abrasive alloys or coolant-through capability should select a different tool.
Highlights
- 2-flute design for efficient chip clearance and smooth milling
- .875 in cutting diameter for precise slot and profile work
- High-speed steel construction for durability in general-purpose machining
- Bright uncoated finish suited for non-ferrous and low-carbon steels
- Double-end configuration provides two cutting ends per tool
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Drill Mills |
Questions about this item
What shank standard does the .875 in Weldon flat on the C42084 end mill follow?
The .875 in shank uses a Weldon flat that matches standard inch-size toolholder flats for secure set-screw clamping.
What clearance does the 1.5625 in length of cut and 6 1/8 in overall length require inside the machine?
The 1.5625 in flute length plus the shank needs at least 6 1/8 in of axial travel and enough radial room for the .875 in cutting diameter.
How is the C42084 double-end mill installed in a Weldon holder, and what step is often missed?
Align the Weldon flat with the set screw, tighten firmly, then verify both cutting ends run true — many forget to check the second end.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
