We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C39600 HSS end mill .25 in diameter .625 in cut length TiN coated Weldon flat shank

Cleveland

Cleveland C39600 HSS End Mill .25 in D .625 in Cut Length

SKU CH-TX4M-81QQD

High-speed steel end mill with TiN coating cuts 0.625 in deep using a 0.25 in diameter

  • TypeMilling
  • High-speed steel construction resists wear during milling
  • TiN coating extends tool life in cutting applications
  • Weldon flat shank secures firmly in tool holders
  • .25 in diameter suits precision milling tasks

Cleveland C39600 HSS End Mill .25 in D .625 in Cut

This Cleveland C39600 is a high-speed steel square end mill with a TiN coating for general milling tasks. It has a 0.25 inch milling diameter and a 3/8 inch shank with a Weldon flat for secure tool holding. The overall length is 3 3/8 inches.

Capacity and headroom: 0.625 in cut length

The 0.625 inch length of cut provides reach for shallow pockets and profiling in steel or aluminium. The HSS substrate with TiN coating handles moderate speeds but will wear faster than carbide in abrasive materials or high-volume production runs.

Highlights

  • High-speed steel construction resists wear during milling
  • TiN coating extends tool life in cutting applications
  • Weldon flat shank secures firmly in tool holders
  • .25 in diameter suits precision milling tasks

Specifications

BrandCLEVELAND
TypeMilling

Questions about this item

Will the 3/8 in shank fit the collet on my older Bridgeport mill?

The Weldon flat on the 3/8 in shank matches standard tool holders on many legacy knee mills, so it seats securely in a Bridgeport collet or end-mill holder.

How can I confirm the TiN coating is performing after the first few cuts?

After initial passes in steel, the gold TiN surface should stay bright with minimal edge wear, and chips will come off clean and curled rather than discoloured or powdery.

More in Power & Pneumatic Accessories

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.