Cleveland
Cleveland C33480 2-Flute HSS High Helix Square Single End Mill pneumatic accessory
A 0.5 inch HSS high-helix square end mill with a 1.25 inch cut length and Weldon flat shank for milling operations
- TypeMilling
- High-speed steel construction resists wear during milling
- Titanium nitride coating extends tool life in production
- High helix angle improves chip evacuation efficiency
- Weldon flat shank ensures secure toolholder grip
- Half-inch diameter suits standard machining applications
Cleveland C33480 End Mill Application
The Cleveland C33480 is a 2-flute high-speed steel end mill with a high helix design for efficient chip evacuation. It suits general milling tasks in steel and non-ferrous metals where a square profile is required. The TiN coating extends tool life during continuous cutting operations. This tool targets machinists and maintenance crews needing reliable slotting and profiling performance.
Weldon Flat Installation Notes
The 1/2 in shank features a Weldon flat that locks securely into a matching end-mill holder with a set screw. Ensure the holder bore is clean and the flat aligns with the screw before tightening. A loose fit or debris on the shank causes run-out and premature wear. The high helix angle demands rigid clamping to prevent chatter during deep cuts.
Pre-Order Compatibility Check
Verify your machine spindle accepts a 1/2 in shank with a Weldon flat drive. Confirm the 3 1/4 in overall length clears your workpiece and fixture without interference. The 1.25 in length of cut defines the maximum depth per pass. This item is not for buyers who need a necked tool for deep-pocket reach or a different coating for high-temperature alloys.
Highlights
- High-speed steel construction resists wear during milling
- Titanium nitride coating extends tool life in production
- High helix angle improves chip evacuation efficiency
- Weldon flat shank ensures secure toolholder grip
- Half-inch diameter suits standard machining applications
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
How do I verify the C33480 is cutting correctly after installation?
Check for smooth chip evacuation through the two high-helix flutes and a consistent finish on the 0.5 in milling diameter during the 1.25 in length of cut.
What comes with the end mill and what must I supply?
The box contains the TiN-coated HSS square end mill with a 1/2 in Weldon flat shank; you must provide a compatible tool holder and coolant.
When should I choose this C33480 over other sizes?
Select this 0.5 in diameter, 1.25 in length-of-cut, 3 1/4 in overall length tool when your operation requires that exact reach and flute geometry.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
