Cleveland
Cleveland C30835 4-Flute Cobalt 8% Roughing End Mill .75 in
A 4-flute cobalt 8% roughing end mill with a .75 in diameter and 1.625 in length of cut for heavy material removal
- TypeMilling
- 4-flute cobalt 8% construction resists heat during heavy cuts
- .75 in diameter handles large material removal efficiently
- 625 in length of cut reaches deep pockets in one pass
- Weldon flat shank locks securely in tool holders
- Uncoated surface suits dry machining without coolant
Cleveland C30835 Roughing End Mill
This 4-flute cobalt 8% roughing end mill is built for aggressive material removal in milling operations. The .75 inch cutting diameter and Weldon flat shank suit CNC machines and manual mills where heavy chip loads are required.
Replaces general-purpose end mills
The cobalt substrate and roughing geometry outperform standard high-speed steel tools when cutting tough alloys or taking deep cuts. The upgrade is worth it when cycle time matters and tool changes must be minimised.
Sustained load behaviour
Four flutes and the uncoated cobalt body dissipate heat during long passes without coolant-through capability. The 1.625 inch length of cut and 3 7/8 inch overall length maintain rigidity in extended reach situations.
Highlights
- 4-flute cobalt 8% construction resists heat during heavy cuts
- .75 in diameter handles large material removal efficiently
- 625 in length of cut reaches deep pockets in one pass
- Weldon flat shank locks securely in tool holders
- Uncoated surface suits dry machining without coolant
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
What shank diameter does the C30835 need in a tool holder?
The cutter uses a 3/4 in Weldon flat shank, so the holder must accept a .75 in diameter with a flat for the set screw.
How should the end mill be seated to avoid pull-out?
Align the Weldon flat with the holder’s set screw, tighten the screw firmly on the flat, then verify zero run-out before cutting.
When does this cobalt rougher need to be replaced?
Replace the tool when the four flute edges show visible chipping, excessive flank wear, or when surface finish degrades beyond tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
