We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black metal plate with dovetail slot and mounting holes, model CM-402

cineMilled

cineMilled Quick Switch Mini Mount Plate CM-402

SKU CH-E9S9-5CBGM

Quick-switch plate lets you move a fully built camera between a Ronin-M/MX gimbal and other supports without removing the dovetail

  • Quickly swap camera between Ronin-M/MX and other supports
  • Leave camera fully built on Ronin factory dovetail
  • Switch platforms without disassembling camera rig
  • Slide on and off for fast transitions
  • Designed specifically for DJI Ronin-M and MX gimbals

Quick Switch Plate for Ronin-M/MX

The cineMilled CM-402 lets you move a fully built camera between a Ronin-M or Ronin-MX gimbal and any other support platform. You keep the factory dovetail attached to the camera so there is no need to disassemble the rig each time. This accessory targets solo operators and small crews who change setups several times a day. It removes the repetitive task of rebalancing and re-rigging when switching from gimbal to tripod, slider or handheld rig.

Thermals Noise and Power Draw

The plate is a passive machined component with no electronics, motors or cooling requirements. It adds no audible noise and draws zero power from the gimbal or camera. Heat dissipation is not a factor because the part does not generate any. Its only physical effect is the slight mass of the aluminium body, which the Ronin-M/MX balances normally during standard calibration.

Dovetail Retention and Workflow Change

By locking the Ronin dovetail to the camera permanently, the CM-402 turns a multi-minute teardown into a single sliding motion. You no longer need tools to remove the dovetail plate or to re-level the camera when returning to the gimbal. The package contains only the mount plate itself; no extra screws, cables or software are included. The time saved compounds across every location change on a shoot day.

Highlights

  • Quickly swap camera between Ronin-M/MX and other supports
  • Leave camera fully built on Ronin factory dovetail
  • Switch platforms without disassembling camera rig
  • Slide on and off for fast transitions
  • Designed specifically for DJI Ronin-M and MX gimbals

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the Quick Switch Mini Mount Plate on my Ronin-M or Ronin-MX gimbal?

Slide the camera with its Ronin factory dovetail into the Quick Switch plate until it locks; the step users often miss is ensuring the dovetail seats fully before tightening any secondary screws.

What maintenance will the Quick Switch Mini Mount Plate need over time?

Periodically check the locking mechanism and contact surfaces for wear or debris; clean with a soft brush and apply a light dry lubricant if the slide action becomes stiff.

What is the first limit I will hit when using the Quick Switch Mini Mount Plate continuously on set?

Repeated rapid swaps can loosen the dovetail clamp tension, so re-tighten the clamp screws between takes to maintain a secure camera connection.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.