CHRISTIE
CHRISTIE DWX851-Q projector lamp 350W 2000 hrs
A 350 W UHP replacement lamp module rated for 2,000 hours, supplied as a complete housing for direct installation
- TypeUHP
- Wattage350W
- Lamp Life2,000 hrs
- Genuine Philips UHP 350W bulb ensures bright, reliable projection
- Pre-assembled lamp module fits Christie projectors for quick installation
- 2,000-hour rated life supports extended use between replacements
- Manufactured to ISO9001 quality standards for consistent performance
- Multiple OEM and compatible versions available to suit requirements
Genuine 350W UHP replacement lamp
The Christie DWX851-Q module supplies a new Philips UHP 350W bulb inside a pre-assembled housing. It is built for Christie projectors that specify the 003-005160-01 part number. The unit arrives ready to install without separate lamp alignment.
Replaces ageing original lamps at 2 000-hour rating
Swapping a dimmed or flickering factory lamp restores rated brightness and colour balance. The change is worthwhile when the existing module has reached or exceeded its 2 000-hour service life or shows premature degradation.
Fits directly into compatible Christie chassis
The complete housing slides into the projector’s lamp bay using the existing latch mechanism. No extra tools, adapters or firmware updates are required. The module frees the operator from handling a bare bulb and reduces downtime to a single cold-swap.
Highlights
- Genuine Philips UHP 350W bulb ensures bright, reliable projection
- Pre-assembled lamp module fits Christie projectors for quick installation
- 2,000-hour rated life supports extended use between replacements
- Manufactured to ISO9001 quality standards for consistent performance
- Multiple OEM and compatible versions available to suit requirements
Specifications
| Brand | Christie |
|---|---|
| Type | UHP |
| Wattage | 350W |
| Lamp Life | 2,000 hrs |
Questions about this item
Which Christie projector models accept the DWX851-Q lamp module?
The DWX851-Q module (Christie part 003-005160-01) is built for Christie projectors that specify this lamp; verify your projector's service manual lists the DWX851-Q or part 003-005160-01 before ordering.
What is the correct way to seat the DWX851-Q lamp housing, and what step do installers often skip?
Power off and cool the projector, remove the lamp door, slide the housing in until the connector clicks, then secure the retaining screw; the step most often skipped is tightening that screw, which can cause ignition failure.
When should the DWX851-Q lamp be replaced, and what indicates end of life?
The UHP 350W bulb is rated for 2,000 hours; replace it when the projector's lamp-hour counter reaches that figure or when brightness drops noticeably and the lamp-warning indicator illuminates.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



